Dicas Reparação




Modelo - Chassis TX100


Pesquisa: TX100 Enviar Dica Resolvida
Resultados 292
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
Logik4298 TX100
Frame scan distorted.IC TDA3651 frame IC.
Logik4298 TX100
Fast tripping.LOPTX
Logik4298 TX100
Dead.D15 ( BY299 ) in psu s/c.
FergusonTX100 Chassis -Turkish
Switches to Stby after a while.Change two 5V regulators in the control board.(TDD1605)
FergusonTX100 59J7
Field collapseFOP chip TDA3652 - check for dry joints at scan coil plug under plastic cross member
FergusonTX100 -Turkish
Switches to Stby after a while.Change two 5V regulators in the control board.(TDD1605)
FergusonTX100
WONT CHANGE CHANNELS WHEN COLDC261 ( 1mfd )
FergusonTX100
Will only tune on channel 1 & 8.IC905.
FergusonTX100
Will not tune in.IC1301 prescale chip.
FergusonTX100
Will not tune in.XL 1801 scope or meter on pin 24 clears fault.
FergusonTX100
Will not store more then one channelTR2016 , D2025 , IC2006 , change R2070 to 5k6.
FergusonTX100
Will not store have to retune at each switch onTR2017 ( BC307 ) u/s in read write modify circuit
FergusonTX100
Width - reduced.R709 o/c.
FergusonTX100
Width - reduced.Coil fitted on E/W PCB pluged into main PCB link it out.
FergusonTX100
Width - reduced & ripply picture.R143 ( 350uf ) high.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads