Dicas Reparação
Modelo - Chassis TCFX500R
Pesquisa: TCFX500R Enviar Dica Resolvida
Resultados 9
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | TCFX500R | PUSHING REC CAUSES REC MUTE | Unit would go into REC MUTE whenever REC was actuated. Normalrecording is not possible. | ||
| Sony | TCFX500R | DEFECTIVE RELAYS CAUSE MOTORBOATING IN RECORD MODE | Intermittent motorboating on record. Meter pegs left ch.This is one of many def. relays in the past month. | ||
| Sony | TCFX500R | INTERCONNECTING PROBLEM (RM-44 WITH TC-FX500R) | When these 2 units are hooked together and the remote FFbutton is pushed, the TC-FX500R goes into the REWIND mode. -HQ COMMENTS: The RM-44 is designed for used with components: ST-JX44,TA-AX44 and a tape deck (TC-FX44 or 500R). In this set-up, the GND | ||
| Sony | TCFX500R | OPEN GROUNDS | Control functions (PLAY, REC etc) are inoperative totally orintermittently, may stop operating during use or prevent use of functionswhen attempting to enter a particular mode of operation. | ||
| Sony | TCFX500R | CHASSIS HEAD ASSY BENT | When put in reverse it only cycles and you cannot remove tapeuntil FF is depressed because the head assy does not drop down completely. | ||
| Sony | TCFX500R | WORN GEAR ASSEMBLY | Clattering in transport, especially when changing directionwas the complaint. Upon my investigation I learned that the noise onlyoccurred when direction of play was changed. | ||
| Sony | TCFX500R | STRIPPED GEARS | Driving and forward cam gears stripped. Head chassis appearsto be free and operation not excessively stiff when moved by hand but thedealer has only sold 3 units so I have not enough to see if it is a trendof failures. | ||
| Sony | TCFX500R | BENT TAB ON HEAD CHASSIS | Head deck would cycle up and down about 3 times after FWDbutton was pushed, then there would be a graunchy noise and deck would gointo FF. | ||
| Sony | TCFX500R | GEAR WEARS | Unit makes grinding noise when reversing. Intermittently willjam at same time noise is heard. Gear is made of soft plastic. Inreverse mode torque is too great and teeth pre-destroyed. |