Dicas Reparação
Modelo - Chassis SPP320
Pesquisa: SPP320 Enviar Dica Resolvida
Resultados 33
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | SPP320 | ERROR ON BASE BOARD | Transistors Q-609 and Q-610 are identified in reverse on theBASE board. -HQ COMMENTS: Thanks for the info. The schematic and board layouts arecorrect in the service manual. Q-609 is a PNP, and Q-610 is an NPN.The right transistors are inserted in thei | ||
| Sony | SPP320 | UNIT DISCONNECTS LINE INTERMITTENTLY | Disconnects after dialing. Problem does not occur at SSC. | ||
| Sony | SPP320 | NO DIAL TONE | No sound on handset. No dial tone when phone off the hook. | ||
| Sony | SPP320 | IF UNIT DOES NOT WORK AFTER MAIN BOARD IS REPLACED | The unit does not work after the main board in either thebase or the handset is replaced. -HQ COMMENTS: The replacement boards have blank ID ROMS. Therefore,after replacing either the handset or base unit board, remove the ID ROMsfrom both old boards ( | ||
| Sony | SPP320 | DIFFERENT MAIN BOARD IN UNIT | Request updated information or supplement manual on Base MainBoard which has part number 1-634-940-11 marked on the board. The mainboard that matches the current schematic and is in current SPP telephonesare marked 1-632-800-12. -HQ COMMENTS: To Tokyo: | ||
| Sony | SPP320 | STATIC IN RECEIVER (BOTH PARTIES) | Excessive noise added to phone line through mic 101 whentouching Handset (cordless) case. Even Handset rubbing against the facecauses noise. All SPP-320s handsets appear to have this problem. | ||
| Sony | SPP320 | NO RING/NO DIAL TONE/LINE LIGHT GOES OUT AFTER A FEW SECONDS | No ring, no dial tone. Line light goes out after a fewseconds. Relay wouldn't engage Q-608 was good, but was not driving relay. | ||
| Sony | SPP320 | INCORRECT PART NUMBER - ANTENNA DUPLEXER DPX1 | The part received from KCP is slightly larger than the one inthe unit. The dimension that causes a problem is the height the one fromKCP is too tall. The cabinet will not close as a result. This part isthe same one used in the SPP-100/110/150/300. I | ||
| Sony | SPP320 | NO CHARGE | Two incidents of bent battery contact springs. | ||
| Sony | SPP320 | INTERMITTENT RINGING | The Handset would only ring sometimes. In addition, theHandset would intermittently not beep when keys were pressed. Flexing theHandset Main PCB would cause the ringer to function. | ||
| Sony | SPP320 | UNIT SEARCHES TOO LONG FOR A GOOD CHANNEL | Unit searches too long for a good channel. | ||
| Sony | SPP320 | INTERMITTENT HANDSHAKE AND STATIC ON AUDIO | Phone would intermittently not lock up, and when it did, therewas static. When handset was taken apart, phone worked. Phone workedbecause antenna was not connected. | ||
| Sony | SPP320 | WHAT IS THE DISCONNECT TIME WHEN USING THE FLASH BUTTON | How long is the line disconnected for when using the flashbutton? -HQ COMMENTS: The line relay is opened for 500msec. | ||
| Sony | SPP320 | NO CHANNEL LOCK | No channel lock (or sometimes only channels 8, 9 and 10).Also applies to serial numbers 12072, 12103 and 12826. | ||
| Sony | SPP320 | POOR AUDIO CONNECTION ON TELEPHONE LINE | Poor connection with outside line. Audio and dial tone barelyaudible or nonexistant both in and out. |