Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
TCL | 65P735 | SEM IMAGEM | parecia ser barra de led queimada | diodo em curto da placa que retifica a corrente dos leds(só trocar por outro equivalente) | reginaldo moronte,eletronica junior caldas novas |
LG | 43UP7500PSF | Linhas no display, parecendo defeito na tela. | R411 na v-com com fulga. | O capacitor esquenta quando liga a TV . | Mariano |
TCL | 55P725 | Não acende o backlight, mas o barramento está bom. | Diodo AD602 em curto. (MBR3200) | Substituir. | Persio (TVCompany) |
SAMSUNG | LE32B530P7 BN44-00260A | Não liga, LED apagado | RP820 em curto, CM852 e CM876 alterados | Substituição dos componentes | Louritronica |
SAMSUNG | LE40B530P7W | Só standby | Fusistor da entrada de tensão aberto. | Troca e reparo | JC Eletrônica Cícero |
POLYVOX | CP150 CP750 | Tape CP-150 Polyvox com um canal baixo somente no VU | C216 (22uF/16V) esgotado | Trocar capacitor | Andypoison |
STANER | MP720 | CANAL B COM SOM DISTORCIDO | FALTANDO A TENSÃO DE +15 VOLTS DO CIRCUITO DE PRÉ TL071 | TROCAR DIODO ZENER DE 15 VOLTS NO PINO 7 DO CI DE PRÉ AMPLIFICAÇÃO | ELVONEUTON FRAGA |
BENQ | FP767 | Sem imagem visivel | Soldas frias fazem com que algusn fusíveis abram ficando o aparelho sem imagem ou inoperante | Substituir fusíveis abertos retificar soldas com defeito | Duarte Pacheco |
SAMSUNG | LE37B530P7 | Cores alteradas | Valores alterados nos parametros do modo de serviço | Repor valores | Matias |
Nokia | SP71D1 and others Stereo Plus | Tv does not start from stand-by. Indicator led blinks quickly | Replace the two smd condensers in parallel between pin 2 of IC NO62 reset line. Remove all of the red glue below the condensers. These condensers must be replaced by new ones of 47nF and 100nF in parallel. IC NO62 TDA8137 sometimes must be also replaced | ||
Daewoo | CP775 | Dead - faint ticking from PSU | LOPTx faulty - check Q401 D18809a4 aka 2SD1880 for s/c and D406 for s/c | ||
Daewoo | CP785 | No picture | Replace IC TDA8385J | ||
Nokia | SP71L1 | Popping sound from the high voltage then shuts off | Change TDA8350Q and the 22ohm resistor if its burned | ||
Sanyo | CTP7135 80P | Startup - takes a long time to startup. | C312 ( 10uf , 35v ) | ||
Sanyo | CTP7133 | HT high (165v) | C312 220µ 25v |