Dicas Reparação
Modelo - Chassis MZ1
Pesquisa: MZ1 Enviar Dica Resolvida
Resultados 33
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | MZ1 | UNIT DISPLAYS "HOLD" (CN-803 NOT CONNECTED) | Unit would not load disk. Unit displays Hold. CN-803 wasunplugged. | ||
| Sony | MZ1 | NO POWER WITH AC ADAPTER (NICAD BATTERY OK); PS-401 OPEN | Unit had no power with adapter, but worked ok with battery. | ||
| Sony | MZ1 | INTERMITTENTLY WON'T ACCEPT MO DISCS (REPLACE REF. # 108) | When trying to load a recordable disk, the unit will eject thedisc immediately. It sometimes accepts disc with unit upside down. Foundpin 66 of IC-801 jumping high but not going back low as recordable discwas inserted. All three units loaded pre-recor | ||
| Sony | MZ1 | NO OPERATION (RESETTING IC801 RESTORED NORMAL OPERATION) | Unit is inoperative. All voltages look good. | ||
| Sony | MZ1 | DISPLAY DIMS DURING RECORD (REPLACE FB310, P/N 1-543-948-11) | Display would dim during Record. | ||
| Sony | MZ1 | DISC ERROR MESSAGE | Unit would not read TOC. The worm gear would not move becauseit was hung up on the optical block. | ||
| Sony | MZ1 | DISTORTION IN LEFT CHANNEL (IC-603 DEFECTIVE) | Distortion in left channel. After warm up, it became justnoise when I used the heat gun. | ||
| Sony | MZ1 | ADJUSTMENTS ARE NOT STABLE | After doing all adjustments and playing the unit for an hour,I would get intermittent audio (tracking or focus problem). | ||
| Sony | MZ1 | INOPERATIVE UNIT | Unit was inoperative and the fusible link PS401 was open.When I replaced the link and plugged in the unit, C5020 became physicallydamaged. | ||
| Sony | MZ1 | RESTORING UNUSABLE M/O DISCS TO USABLE CONDITION | The display shows UTOC ERROR when trying to read an M/Odisc. This problem may have been caused by the customer moving the unitwhile it was updating the UTOC area after recording. The owner's manualindicates that the disc must be replaced. | ||
| Sony | MZ1 | LOAD/EJECT VERY SLOW, MOTOR DRIVER IC-802 DEFECTIVE | Load/eject was very slow. | ||
| Sony | MZ1 | WILL NOT EJECT DISC (MECHANISM JAMMED BY DROPPING UNIT) | Disc was stuck in unit. I've seen this problem many times. | ||
| Sony | MZ1 | NO OPERATION W/ NICAD BATTERY, Q-401 (MAIN BOARD) DEFECTIVE | Unit would not power up when using the nicad battery. | ||
| Sony | MZ1 | DIGITAL NOISE IN AUDIO, CAUSED BY COLD SOLDERING OF IC-801 | Unit will intermittently put out strange digital sounds.These sounds are in both left and right channels. When I touched thesyscon IC-801, the sounds got worse. | ||
| Sony | MZ1 | TRACKING PROBLEM AFTER 2 HOURS, TRACKING GAIN MIS-ADJUSTED | After two hours of Play, unit had a hard time reading thedisc. You could hear the sled moving a lot more than normal. |