Dicas Reparação




Modelo - Chassis M3


Pesquisa: M3 Enviar Dica Resolvida
Resultados 292
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
17 A2-M398
S/ imagem e s/ som chuviscos Varicap
MotorolaRádio móvel GM300
Potência baixa de transmissãoQ2330
MotoradioAuto rádio ARS M32/B
Sem AM e sem FMD601 (1N753) e CI801 (MC1310)
Philco17 A2-M398
S/ imagem e s/ som - chuviscosVaricap
Philco 17 A2-M398
S/ imagem e s/ som -chuviscos Varicap
SonyXM3046
DISTORTED AUDIO OUTPUTS The Audio outputs of the Amplifier may be distorted. This maybe caused when the Power Mosfets not properly soldered to the PC board.
SonyCVPM3
HERRING BONE OR DISTORTED VIDEO - C394 ON VA-76 BD LEAKY Picture has a herring bone distortion in the video. Found ripple on 2.5V line on VA-76 Board.
SonyCVPM3
BAD PIX THROUGH VIDEO INPUT - REPLACED C216 ON VA-76 BOARD Unit came in with bad picture through Video Input.
SonyCVPM3
DISTORTED PICTURE ON PRINT PAPER EE without power on picture wavy, sync was clipped. Distorted picture when print on paper. Found a lot leaky 15u 10v capacitors.
SonySSM33
WRONG PART L/R SPEAKER GRILLE FRAME Left speaker grille frame part X49447332 is incorrect aswell as the right side X49447342.
SonyEXM302
NO AUDIO OUT WHEN HIGH LEVEL INPUT IS USED Units either have no audio or intermittent audio when the highlevel inputs are used. Found the solder connections were broken and thetraces for the CN901 are lifted. It appears that more support may beneeded for the jack to prevent this. -HQ COMMENTS:
SonySSCM354
UNIT DEAD DC/DC CONVERTOR BAD- REPLACE Unit dead, dc/dc convertor bad. Serial number 16981 and11276 also included.
SonyPVM3230
VERTICAL LINES ON SCREEN CAUSED BY COMB FILTER CFB301 Vertical lines on screen 1/2/inch apart.
SonySSCM354
DC/DC CONVERTOR SHORTS BLOWING FUSE DC/DC convertor shorts, blowing fuse.
SonyXM3040
INTERMITTENTLY IN PROTECT (CLEANED ELECTROLYTE OFF MAIN MCB) Unit would intermittently go into protect mode without anyinput or output connections. Found C507 leaked electrolyte onto PCB andcaused Q505 to bias on.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads