Dicas Reparação
Modelo - Chassis M203
Pesquisa: M203 Enviar Dica Resolvida
Resultados 19
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Teac | CTM203 PC04A | No Power | Check / Replace power switch, it read zero ohms at contacts - however carbon build-up stops p.s.u. from starting | ||
| Sony | GDM2036S | SHUTDOWN DUE TO Q204/H. OUT FAILURE ON D3 PCB | The monitor shut down due to Horiz. scan failure. The H.Out: Q204 and B+/H. Size Reg.: Q217 failed. B+ Filter C405 had lowcapacitance. | ||
| Sony | GDM2038 | INTERMITTENT LOSS OF SYNC | Intermittent vertical sync and hor sync when first turned on.Symptom only showed up on VGA graphics mode. Found IC101 to betemperature sensitive using freeze spray and pyco pen. | ||
| Sony | GDM2038 | SHUT DOWN DUE TO Q401 COLD SOLDER | Unit comes on with bright raster and shut down. | ||
| Sony | GDM2038 | UNUSUAL PIN TYPE OF DISTORTED PICTURE | Horizontal pin type of indentation on both left and rightsides of screen at about vertical center. Not your typical pin type ofdistortion. Only the center 1/3 of the screen was affected. | ||
| Sony | GDM2038 | PICTURE IS UNSTABLE WHEN CHANGING FROM TEXT TO GRAPHICS MODE | |||
| Sony | GDM2036S | PICTURE IS UNSTABLE WHEN CHANGING FROM TEXT TO GRAPHICS MODE | |||
| Sony | GDM2036S | NO HIGH VOLTAGE, AND NO HSYNC DUE TO IC101 (H OSC) | All Power Supply Voltages are OK but, No Horizontal drivesignal from IC101. | ||
| Sony | GDM2038 | RECOMMENDED SCREEN CLEANER | |||
| Sony | GDM2036S | RECOMMENDED SCREEN CLEANER | |||
| Sony | GDM2038 | DIFFICULTY ADJUSTING THE WHITE BALANCE | |||
| Sony | GDM2036S | RECOMMENDED SCREEN CLEANER/USE (3-731-449-01) DRY SOFT CLOTH | This monitor has an anti-glare coating on the CRT. What typeof cleaner is recommended? -HQ COMMENTS: All GDM Monitors unlike CPD Monitors have a coating on thescreen surface. We recommend a dry soft cloth (P/N:3-731-449-01) to cleanthe screen surface. | ||
| Sony | GDM2038 | RECOMMENDED SCREEN CLEANER/USE (3-731-449-01) DRY SOFT CLOTH | This monitor has an anti-glare coating on the CRT. What typeof cleaner is recommended? -HQ COMMENTS: All GDM Monitors unlike CPD Monitors have a coating on thescreen surface. We recommend a dry soft cloth (P/N:3-731-449-01) to cleanthe screen surface. | ||
| Sony | GDM2036S | PICTURE STRETCHES VERTICALLY DUE TO IC-201 | After warm up, the picture will start to stretch vertically atthe bottom. Customers says it would take anywhere from 1/2 to 2 hours.By heating and cooling IC-201 I was able to produce the problem. | ||
| Sony | GDM2036S | NO OPERATION, SCREACHING SOUND FROM THE POWER SUPPLY. |