Dicas Reparação




Modelo - Chassis KV2650R


Pesquisa: KV2650R Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV2650R
Q-007 AND Q-008 SHOULD NOT BE IN PARTS LIST Q-007, Q-008 are listed in the parts list but not found in theschematic. -HQ COMMENTS: These two transistors were listed by mistake. Pleaseremove them from your service manual.
SonyKV2650RX
MISSING PART NUMBER, CP003 1-417-087-00 Part number is missing from service manual.
SonyKV2650R
SNOWY PICTURE, REPLACED BAND SWITCH IC002 The set would occasionally tune in the VHF low channels. Allother channels were snow. We found the band switch IC to be defective.This is becoming more common problem with the units using the LA7920 IC.
SonyKV2650RX
NO PICTURE, REPLACE IC002 VC voltage on chs. 2/3/4 was low - below 2 volts. Chs. 5/6and all others were fine. Found 4 volts at Pin U on tuner.
SonyKV2650R
AFT DRIFT, LEAKY Q024 When you tuned a station it appeared as if the AFT wassearching before it locked in on the strongest portion of the signal.VC was changing slightly before it locked.
SonyKV2650R
NO OPERATION, REPLACED D021 Unit cannot be turned off except by master switch, no functionon any mode, i.e. power on/off volume up/down, channel up/down, pictureup/down etc. Voltage on Pin 2 on IC001 was high (4.8V). Found D021leaky (500K).
SonyKV2650R
SET WOULD NOT GET SOME CHANNELS, REPLACE IC001 Set would not get channels 2,3,7,8 on cable. Changed IC001.Set would then pick up missing channels, but was missing others. IC waschanged again and would pick up all but channel 13. Set was delivered tohome and would receive all channels but 3. Set r


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads