Dicas Reparação




Modelo - Chassis IKC2


Pesquisa: IKC2 Enviar Dica Resolvida
Resultados 36
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
ThomsonIKC2
No col via scart - ok off air4.43Mhz Xtal
TelefunkenIKC2
No sigsRH04 27K 30v supply
SabaIKC2 M5506
No signalsReplace II06 SDA 3202 in tuner
PhilipsIKC2
ht low at 30vCP51 100µ 250v ht smoother o/c
NordmendeF20-9. -similar to IKC2 chassis
Won't start, if vertical deflection coils (yoke) removed, Starts with EHT about 10-12KV s.Replace DL13.
FergusonIKC2 A51F
Tuning modepress and hold the PROG button in for a few seconds B4 it displays the on screen graphics. To unskip channels; display the tuned station by pressing PROG for a few seconds and then press the red fasttext button to store.
FergusonIKC2 A51F
Sound lowWeak audio o/p at pin 10 IF can, CS14 1µ 63v in the can low cap
FergusonIKC2 A51F
Dead - LED flickers twice brieflyLOPTx
FergusonIKC2
WONT COME OUT OF SBY , WORKS IF FIELD COIL PLUG REDF16 BY398SC.
FergusonIKC2
Trips slowly ( once per second ) no obvious shortsTV01 ( BC558 ) check by replacement
FergusonIKC2
Trips off at sw onTL082 op amp IC
FergusonIKC2
Tripping - standby light lit.DL11 ( BA157 ) s/c , res RL11 o/c.
FergusonIKC2
Tripping ( red LED ) at 1 second intervals.TV01 ( BC558 ) leaky , due to LOPX.
FergusonIKC2
TrippingTV01 ( BC558 ) , AND FIELD O.P. CHIP IF01
FergusonIKC2
Standby - switching to standby on channel ch.Replace 2.2k RP26 with a 1.5k if any lower blows S2000AF


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads