Dicas Reparação
Modelo - Chassis ICC8
Pesquisa: ICC8 Enviar Dica Resolvida
Resultados 45
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Ferguson | ICC8 | Field lin | 2v1 zener in field o/p chip kit u/s | ||
| Ferguson | ICC8 | Field collapse | TDA8178 FOP chip dry joints & RF33 o/c (1R8 or 0R33) | ||
| Ferguson | ICC8 | Dead with HT present but no line drive | CP59 leaks causing corrosion of pcb to RP51 causing HT to rise & set trip | ||
| Ferguson | ICC8 | Dead 1.6A fuse o/c | BUH515 chopper tr s/c; DP50 BY399 HT rect s/c - fit repair kit which includes above parts + CP29 2n2, TEA2261, CP55 220µ & various diodes | ||
| Ferguson | ICC8 | Dead - no st/by LED | bridge hairline crack at solder pad of DP65 ( 24 volt rectifier feeding line driver ) | ||
| Ferguson | ICC8 | Dead - no 320v reaching chopper tr | RP01 & 02 1R2 o/c; CP04 4n7 1kv across mains rect s/c | ||
| Ferguson | ICC8 | Dead - brief burst of HT/EHT with HT at 115v then trips silently - same on dummy load | DL13 BY397 s/c | ||
| Ferguson | ICC8 | Dead | Check for 10V StBy 6V at TV06 IV01 | ||
| Ferguson | ICC8 | Dark green with streaking | RT24, 44, 64 39k 1W fback Rs on crt base all o/c | ||
| Ferguson | ICC8 | Contrast very low | Check 39k feed resistors on crt base & 1k flashover prot Rs RT26,46 & 66 | ||
| Ferguson | ICC8 | Blows LOT at switch on HT ok. | CL21 11n5 (low capacitance) | ||
| Ferguson | ICC8 | BLOWS FUSE INT | BRIDGE RECT. DIODE PROTECTION CAPACITORS INT SC | ||
| Ferguson | ICC8 | Blank raster - sound ok | DL42 1N4148 leaky in pulse conn to pin 35 TA8659CN dec/tb chip | ||
| Ferguson | ICC7/ICC8 | Cuts out when going to st/by - no Red LED | TV01 BC558C prot Tr | ||
| Ferguson | B59F -ICC8 | POOR PICTURE WITH STREAKS | CHECK R704 1.5K OHM ON CRT BASE |