Dicas Reparação




Modelo - Chassis ICC7


Pesquisa: ICC7 Enviar Dica Resolvida
Resultados 99
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
FergusonICC7
DEAD FUSE FP01 OC CHOPPER TP29 SCIP01 TEA2261 + RP62 OC 0R1
FergusonICC7
DEAD , LINE OSC WONT START.IRO1 MICRO ( ST 6391B1/BC ) PtNo IOO35850
FergusonICC7
DEAD , LED SHOWS REDCHECK 1st RP62 0.1ohm 24v. OR IF TDA8178F , FIELD IC ( MAY NOT RUN WITH IC DISCONNECTED , REPLACE! )
FergusonICC7
DEAD , NO LED , TRIPPINGDP17 BA157 ( PRODUCES EOR VOLTS FOR PIN 6 OF IP01 )
FergusonICC7
Dead - psu tickingRP62 0R1 o/c; IF01 TDA8178F S/C
FergusonICC7
Dead - no O/P from PSU.CHECK DP 28 ON PRIMARY , BA157 - BA159
FergusonICC7
Dead - no LED lit - set tripping.DP17 ( BA157 ) s/c.
FergusonICC7
Dead - loptr s/c Replace with S2000N & tuning cap
FergusonICC7
Dead - lopt tr s/ccheck CL21 ( usually 11 nF ) in this case it was down to 12 pF !
FergusonICC7
Dead - LED shines red.RP62 ( 0.1ohm ) o/c , TDA8178F frame IC IF01.
FergusonICC7
Dead - LED red for about 10 seconds then out.TL17 s/c , DF16 ( BA157 ) , DL18 ( 1N4148 )
FergusonICC7
Dead - eht comes up then off with screechCorrosive glue under RP39 120k had eaten away print
FergusonICC7
Dead - brief Led lights at sw onCP59 3300µ leaked onto print corroding track
FergusonICC7
DeadMains sw; IR01 micro
FergusonICC7
DeadLOPtr S2000AF s/c - dry joints caps in line stage


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads