Dicas Reparação
Modelo - Chassis ICC7
Pesquisa: ICC7 Enviar Dica Resolvida
Resultados 99
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Ferguson | ICC7 | Tripping at 1 second intervals. | TV01 ( BC558 ) leaky , ck by replacement only , may be caused by faulty LOPTX. | ||
| Ferguson | ICC7 | Top frame foldover. | DL09 ( BA157 ) leaky , IF01 ( TDA8178F ) | ||
| Ferguson | ICC7 | TOP FOLDOVER | CHECK 65v RAIL , IF LOW AT 32v DL09 OR TDA8178F | ||
| Ferguson | ICC7 | TL17 LINE DRIVER FAILS WHEN LOP ENERGISES | CHECK DF16 BA157 FIELD OP. STAGE | ||
| Ferguson | ICC7 | Strong EHT rustle at sw on then cuts out | CP59 3300µ 35v leaked & corroded print | ||
| Ferguson | ICC7 | STARTS then SHUTS DOWN | CHECK HT , IF OVER 100v P/S OK , Check for 9V pin 40 IV01 5V pin 42 IR01 | ||
| Ferguson | ICC7 | Sound low/weak | CS14 1µ 63v in IF module | ||
| Ferguson | ICC7 | Sound low & dist | C514 1µ 63v in IF can | ||
| Ferguson | ICC7 | Sound barely audible | Replaced 5 electro caps in if module | ||
| Ferguson | ICC7 | Smeary with poor col | RT24/44/64 39k 1w resistors on crt base or TEA5101A RGB o/p chip | ||
| Ferguson | ICC7 | RP62 in field cct goes o/c at sw on | IF01 TDA8178F s/c | ||
| Ferguson | ICC7 | RG85 on NS pcb o/c | TG76 BD137 leaky | ||
| Ferguson | ICC7 | Remote cont does not operate & red "P" displayed | Switch on at mains switch while holding the P+ and P- on the front controls and r/c will operate. | ||
| Ferguson | ICC7 | Psu starts and shuts down immediately | Replace TDA8178F field IC and check DL09 BA157 ( pin 12 lopt ) | ||
| Ferguson | ICC7 | Poor focus | LOPTx |