| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| SABA, NORDMEND, FERGUSON | ICC6 ICC6 | Imagem desloca-se até ficar com uma barra lateral | Transistor TV71 (BC857) SMD | ||
| Thorn | ICC6 C51T | No pic - blank raster with fb lines - sound ok; OSD OK if A1 advanced | Replace TV92 (BC858B) surface mounted transistor | ||
| Saba | 6317 ICC6 | No sound | Replace TV86 SMD transistor. | ||
| Ferguson | ICC6 | Very dark picture (All Cathodes measured 190volts | TB11 (BC557 on CRT Base) | ||
| Ferguson | ICC6 C51F | Service mode entering | Put the TV into stby.then switch off at mains... wait until the stby led goes completely out. switch on at the mains whilst holding down the Blue fastext key on the r/c. let the key go when TV comes on . the n press the Blue key again and a menu will come on screen. Vol +/- moves menu sideways. the Blue key moves down the menu. vol +/- alters the values...scroll all the way down the menu to find "store" to keep changes.remove mains to get out of menu." | ||
| Ferguson | ICC6 C51F | Bright raster with fb lines aft LOPTx replacement | RL11 (15r fusible) immediately behind the lopt | ||
| Ferguson | ICC6 C51F | LOPTx arcing | Replace LOPTx HR7269 resulted in 2 x RGB o/p Trs damaged BF871 & G2 cap 10,000pF 3kv leaky & TB11 BC557C on crt base | ||
| Ferguson | ICC6 | When playing MACRO encoded tapes AV time constant | Replace CV86 with ( 8.2nF ) & RV64 with ( 12K ) & RV66 with ( 15K ) | ||
| Ferguson | ICC6 | Trips 9 times then dead | TL90 BC848B & TF01 BC848B in beam lim faulty tho check ok out of cct | ||
| Ferguson | ICC6 | St/by only - LED flashes | Dis pin 4 from reg IC TDA8139 (Dis prot) brought up blank raster with no OSD, fitted new proc original is type ST6393B1/ZM, but the Seme CD advises using ST6397BB1& replace TDA8139 reg which was also faulty | ||
| Ferguson | ICC6 | sizzling sound from lopt | LOPT replaced | ||
| Ferguson | ICC6 | Removing child lock | 1 switch to standby 2 switch off with mains and let light go out 3 switch on mains while holding standby on remote for 6 secs 4 a red key shows it is locked ,toggle on/off with +/- buttons on remote | ||
| Ferguson | ICC6 | No video o/p intermit | TV92 BC858B sm | ||
| Ferguson | ICC6 | No raster until A1's advanced then blank | dry joints around loptx | ||
| Ferguson | ICC6 | No G2 volts | C814 |