Dicas Reparação
Modelo - Chassis FX310
Pesquisa: FX310 Enviar Dica Resolvida
Resultados 22
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDFX310 | INTERMITTENT MOSAIC PICTURE (FOUND SYNC GENERATOR IC704 BAD) | Camera had intermittent mosaic type picture upon power on.This would happen every 4-5 times of powering unit on and off. | ||
| Sony | CCDFX310 | STRANGE INTERMITTENT MECHANICAL PROBLEMS/REPLACE CAPSTAN MOT | Unit would intermittently not load tape in or out, or capstanwould run away, false tape in or out. -SOLUTION :Replace capstan. | ||
| Sony | CCDFX310 | WRONG PART NUMBER - REF #1 / SEE FPR O2515 | Part Numbers for cabinet(Ref.1) are reversed for FX310 andFX311. These models do not follow normal Sony model numbers for color.(Main model - black, add one to last digit makes it grey)Actual color on CCDFX310 is charcoal and CCDFX311 is black. | ||
| Sony | CCDFX310 | UNIT THINKS THERE IS A TAPE IN IT/RESOLDER IC501 | Unit cycles as if there was a tape in it. | ||
| Sony | CCDFX310 | GRAINY PICTURE IN CAMERA STANDBY/REPLACE IC707, CS37 | Distorted camera video very grainy almost digital looking. | ||
| Sony | CCDFX310 | CAMERA COMPLETELY DEAD/REPLACE X503 | Camera completely dead. | ||
| Sony | CCDFX310 | CCDFX310/FX410 CN002 RESOLDER | Intermittent or no audio and video in playback. | ||
| Sony | CCDFX310 | CAM SECTION WILL NOT TURN ON,VTR SECTION WORKS OK Q903/CD96 | Could not power up camera section. At power on, you couldhear the iris click, then camera would shut down. VTR section will powerup and run normally. | ||
| Sony | CCDFX310 | PART NUMBER FOR IRIS ASSEMBLY/USE 3-708-486-01 | Iris assembly is easy to change, but not available. You haveto replace the entire lens. Iris assembly can be removed by 1 screw. | ||
| Sony | CCDFX310 | NO EE VIDEO/REPLACE TIMING GENERATOR IC 801 | Unit had no EE video. | ||
| Sony | CCDFX310 | PARTIAL ZOOM OPERATION/REPLACE C872 CS-37 BOARD | When zooming to wide angle, the zoom drive would stop, and thezoom display was incorrect. IC852 pin 3, 9, and 10 had input from zoompotentiometer. Pin 10 of IC852 was .97 volts instead of 2.7 Volts. | ||
| Sony | CCDFX310 | UPPER CABINET PART NUMBER INCORRECT | The description of the part is not correct - X-3941-666-1 isfor the FX310 and X-3941-211-1 is for the FX311. | ||
| Sony | CCDFX310 | WRONG LEFT CABINET ASSEMBLY ORDER | Ordered left cabinet assembly for CCDFX310 which is gray incolor and received a black left cabinet assembly. Are the part numbersin the manual for the FX310 and FX311 switched? | ||
| Sony | CCDFX310 | NO COLOR ON PLAYBACK, L305/VA71 BOARD | I put in WR5 9NS color bar tape and scoped IC301 pin 42 CRF inbut there was no signal. I found L305 open. The CRF passes from a .01uFcap through a 1k resistor to L305 which is part of a low pass filter.L305 had RF going in and nothing coming out. The | ||
| Sony | CCDFX310 | AVAILABILITY OF FP-443 BOARD | What is the part number for the FP-443 flex board? -HQ COMMENTS: This part is not available separately. It is supplied withthe LS Chassis Assy (X-3941-265-1). |