Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | TCFX120 | CAPSTAN WASHER | FPR L1559 suggests using part number 7-623-921-01. This willnot work. -HQ COMMENTS: If this does not work, use original washer. There haveonly been two reports of this symptom. | ||
Sony | TCFX110 | MECHANISM IS DIFFERENT FROM WHAT IS SHOWN IN MANUAL | There are some differences in the mechanism when compared tothe exploded views in the S/M. A pinch roller was ordered and it did notfit. -HQ COMMENTS: There are 2 different mechanisms used in the TC-FX110.The early units have mecha type TCM-YM47CW-62, | ||
Sony | TCFX120 | AUDIO DISTORTED - CAPSTAN BECOMES DISLODGED | We have had several reports of the capstan becoming dislodgedon this model. This generally occurs when the customer inserts thecassette incorrectly and tries to close the door. The retaining washergives way and the capstan is pushed back. | ||
Sony | KV27FX10 | INTERMITTENTLY GOES TO DARK RASTER ONLY WITH RETRACE LINES | IC-1702 had cold solder joints causing loss of 9 voltsregulated. Easy point to check for 9 volts at the VHF-UHF tuner. | ||
Sony | TCFX707R | SEVERAL PARTS INSTALLED BACKWARDS ON THE NEW PC BOARD | After installing new PC board, several problems occured.After troubleshooting PC board, the following components were found to beinstalled backwards: Q-303, Q-304, F-101, F-201, IC-304, Q-301 and Q-302. | ||
Sony | TCFX160 | NO PLAYBACK OF PRERECORDED TAPES | In playback mode, the line input signal is present at theline out jacks: Unit is stuck in the record mode. IC-311/pin 42 is alwaysless than 1 volt. IC-381/pin 11 toggles correctly. | ||
Sony | TCFX110 | PART NUMBER FOR T-REEL ASSEMBLY | The part number for the take up reel assembly is not listed inthe service manual. -HQ COMMENTS: Please refer to the TC-FX150 service manual since thesedecks are similar. The part number is 4-894-963-01. | ||
Sony | TCFX33 | AMS ADJUSTMENT | Please reference page 52 of the manual and look at No. 401. Iwould like to know if there is any information regarding the adjustment ofthis plate. -HQ COMMENTS: This is not an adjustable plate. The pins on the plateare used to lock the head plate in p | ||
Sony | TCFX707R | NO/INTERMITTENT TAPE TRANSPORT | Tape will intermittently stop or not run at all. Tech FlashNo. 003 dated 3/11/85 says to tighten gnd screw and add a star washer tosyscon board. I tried this, it made no difference at all in the problem. | ||
Sony | TCFX110 | MISSING PART NUMBER | The part number for the flywheel is not shown. -HQ COMMENTS: The part number is 3-390-806-01. | ||
Sony | KV21FX1MT | SEVERE PINCUSHION DISTORTION (BOTH SIDES), REPLACE C-820 | Severe pincusion distortion on both sides, controls have noeffect. L-871 got very hot. | ||
Sony | TCFX410R | LINE INPUT SWITCHED TO OUTPUT IN REC OR PB | Signal at the Line In jack is always coming out the Line Outjack. Even when unit is put in Play mode, the input signal is switched tothe output. | ||
Sony | TCFX7 | PL802 | On page 3 of S/M, reference is made to a PL802. This is alsoshown in schematic on page 39. This is the rotation detector lamp.In the parts list there is a reference to PL801 only. I need a partnumber for PL802. | ||
Sony | TCFX4 | PART NUMBER MISSING | The ribbon cable from the function LED board to the switchesis torn. A replacement is needed. The part number on the LED board is1-604-291-00, and is not available. There is no part number shown for theribbon cable by itself. -HQ COMMENTS: The functi | ||
Sony | TCFX510R | INCORRECT DESCRIPTION IN S/M | Correct P/N for case, silver should be 3-307-532-31 and forblack one should be 3-307-532-11. -HQ COMMENTS: We will issue a Service Bulletin. |