Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CFSW308 | DECK A NO MECHANICAL MOTION - REALIGN OR REPLACE BELT | Belt comes off its pulley (#158 X-4920-922-1). Pulley (W)assy (10% of all deck problems). | ||
Sony | CFSW308 | NO AM/ NO TUNING CONTROL RIGHT OR LEFT CHANNEL MISSING. | Unit came in with no am. Other units had no tuning control.The third unit had left channel missing. Upon taking the units apart, Isaw that the tuner board had come loose and was sitting crooked. All ofthese 3 boards had cracks right where the screw # | ||
Sony | CFSW308 | NO DC POWER - REALIGN BATTERY TERMINAL BOARD | The battery terminal board (4) is misaligned, causing thepositive terminal of the board not to make contact with the battery. | ||
Sony | CFSW308 | NO AUDIO - UNSOLDER SHORT ON MAGNETIC HEAD | No audio, the (A) deck head wire is shorted, causing the unitto have no audio when the (A) head wire is plugged in. When you unpluggedhead wire (A) deck, audio comes on. | ||
Sony | CFSD960 | NO TAPE FUNCTIONS | No tape function, upon opening saw that second lever waspopped out of place, put back in place and adjusted unit. | ||
Sony | CFS905 | UNIT DEAD - REPAIR AC ADAPTOR JACK | AC ADAPTOR HAS RING CRACKS ON PINS. I SEE THIS ON MOST MODELSTHAT COME IN. | ||
Sony | CFS905 | AUDIO BOARD WITH CNP2-3PM CONNECTOR TO TAPE. | New audio board uses three pin tape motor connector. Oldaudio board used four pin tape motor connector. | ||
Sony | CFS204 | NOT ENOUGH TAKE UP TENTION - REPLACE IDLER, REF 167 | The spring on the lever arm, Idler is not strong enough. Ihad to add strength to the spring and replace the idler. | ||
Sony | CFS202 | NO TAPE FUNCTIONS - REPLACE BELTS | Found 1 belt broken, the other weak. | ||
Sony | CFS202 | PART # FOR BRASS THRUSTER & SPRINGS | Mech squeeked, hole in brass thrusters, Part #s not inmanual. Replace thrusters & springs. | ||
Sony | ICFSW30 | INTERFERENCE IN SW BANDS | SW band gives loud noise and no reception of signal on anyband. There is a ceramic capacitor mounted on main board between pins 5and 6 of CN1. This capacitor is bent downward and presses against thehigher numbered pins of CN1. This cap is not shown in | ||
Sony | ICFSW15 | THE UNIT IS DEAD - RESOLDER MINUS BATTERY TERMINAL | The unit will not turn on with battery power. The minusbattery terminal is disconnected. It is not soldered well between theminus battery terminal and the main PCB. | ||
Sony | CFSW504 | NO FAST FORWARD OR REWIND. | No Fast Forward or Rewind. The spring that pushes FF andRewind lever up, pops out of place. The spring is located under theflywheel.ref 219 FF Lever p/n 4-928-993-01.ref 220 REW Lever p/n 4-928-992-01. | ||
Sony | CFSW304 | NO FAST FORWARD OR REWIND. | No Fast Forward or Rewind. The spring that pushes FF andRewind lever up, pops out of place. The spring is located under theflywheel.ref 219 FF Lever p/n 4-928-993-01.ref 220 REW Lever p/n 4-928-992-01. | ||
Sony | CFS204 | NO FAST FORWARD OR REWIND. | I am sorry it took so long to reply to your fax(A920831). OurNational Refurbishing Center gathered the information which is included inthis report. Steve Fritz, a supervisor also sent a list of models whichuse the same spring assembly. I am sending you h |