Dicas Reparação
Modelo - Chassis D9
Pesquisa: D9 Enviar Dica Resolvida
Resultados 103
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Toshiba | 32WD98B | St/by only | HT present at 125v, eeprom faulty also C872 in 16v supply leaky causing low volts of 8v | ||
| Toshiba | 28WD98B | St/by only | HT at 71v (125v), HIC1016 Z801, R479 68R 1/2w fusible o/c | ||
| Toshiba | 259D9B | No sound from cold | Replace 470µ smoothing cap in 12v supply in psu near LOPTx | ||
| Toshiba | 259D9B | No sound & o/p IC getting hot | AN7171K o/p ic & check 10µ elects in cct | ||
| Toshiba | 259D9B | No sound | Sound o/p chip AN7171NK blasted due to hi volts caused by C866 & 869 10µ 50v in psu pri | ||
| Toshiba | 259D9B | INT. SOUND | Q196 INT. OPEN | ||
| Toshiba | 259D9B | INT NICAM | DRY JOINT ON QG16 5v REG ON NICAM PCB | ||
| Toshiba | 259D9B | Int loss of sync | Dry joints ICF01 IC on Txt panel | ||
| Toshiba | 259D9B | Field foldover | C313 220µ | ||
| Toshiba | 259D9B | Dead - st/by led flashes | D819 | ||
| Toshiba | 259D9B | Dead | C820/838/840/844/845/846/847/501/866/869 plus the the 2SD1279 at 8UKP(SEME) the 5.6 ohm 20W surge limiter, Q802 a 2SA1012 after all this the power supply ran but was obviously under stress - C462 2700pF 2kv s/c | ||
| Toshiba | 218D9B | No pic - blank raster when A1 advanced - sound ok | No scastle pulse pin 35 TA8659N - C410 2700pf dry joint (Under plastic frame by LOPTx) | ||
| Toshiba | 218D9B | Field lin stretched at top | C317 2µ 50v, C308 2µ2 50v - little red caps near fop chip | ||
| Philips | DVD951/781 | DOS / MENU - SEM COR OU COR DIFERENTE. | Ao ligar o aparelho sem o disco aparece menu branco e preto e com flicker de 50Hz, executar acerto de configuracao descrito na pag. 67 do Manual do usuario. Manter pressionadas as teclas STOP e SOUND ligando pela tecla POWER, apos aparecer NTSC | ||
| Sony | EXCD90 | CD DOES NOT PLAY, DISPLAY READS E-04 | The LCD display of the unit reads E-04. This may be caused bythe CD making contact with the chucking arm (ref# 122). This may cause theCD not to spin and eventually displaying an error message. |