Dicas Reparação
Modelo - Chassis CDX5060
Pesquisa: CDX5060 Enviar Dica Resolvida
Resultados 33
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDX5060 | WILL NOT ACCEPT CD, "LOAD" FLASHES (RE-ALIGN ST LEVER) | When disc is loaded, unit will not chuck disc and LOAD continues to flash. Disc is ejected a few seconds later. Found ST lever pinned between chassis (R) assy and slide lever in top chassis assy. | ||
| Sony | CDX5060 | DISPLAY SHOWS "E99" (REPLACE Q1 AND D801 ON SENSOR BOARD) | Plays 30 minutes, then won't accept CD and E99 displayed. | ||
| Sony | CDX5060 | NO FUNCTIONS, MAIN BOARD OVERDISSIPATED AT IC302 | Unit had no functions. Traced problem to IC302, which causedthe Main board to be overdissipated. | ||
| Sony | CDX5060 | SCRATCHING NOISE WHEN CD STARTS OR STOPS | Units would make a scratching sound when the CD started up orwhen Off or Eject was pressed. | ||
| Sony | CDX5060 | NO POWER (INTERMITTENT), REPLACE FLEX BOARD P/N 1-646-953-11 | The unit has no power or has intermittent power. The powerwould cut in/out as the flexible board was moved. | ||
| Sony | CDX5060 | DISC CHUCKING NOT COMPLETED DURING LOADING, GEAR NOISE HEARD | The unit will pull in the disc, but will not chuck the disc.Gear noise can be heard while unit should be chucking the disc. | ||
| Sony | CDX5060 | NO DISPLAY (REPLACE D501, P/N 8-719-921-82) | The LEDs and display are not lit. Found D501 shorted. | ||
| Sony | CDX5060 | WILL NOT LOAD CD/GRINDING NOISE (STRAIGHTEN REF. # 10) | When CD is loaded into unit, Load will flash for about fiveseconds, and there will be a grinding noise before CD is ejected. | ||
| Sony | CDX5060 | UNIT STAYS IN TEST MODE (REPLACE IC501, P/N 8-759-167-49) | When powered up, display of unit goes through test modefunction. Reset has same effect. When AM, FM or CD is selected, unitgoes through corresponding test mode function. | ||
| Sony | CDX5060 | NO POWER (REPLACE X502, P/N 1-579-886-21) | Unit had no power and would not even reset. | ||
| Sony | CDX5060 | NO AUDIO FROM SPEAKERS (REPLACE C572, P/N 1-135-159-21) | Unit has audio from pre-amp output but not from speakers. AMPB+ line from IC503 to IC701 was being held low. | ||
| Sony | CDX5060 | FACEPLATE WON'T LOCK ON UNIT (RE-INSTALL SCREW IN LOCK ASSY) | Front panel will not lock onto front of main unit. | ||
| Sony | CDX5060 | P/N FOR D515 NOT SHOWN IN SVC. MANUAL (P/N IS 8-719-921-98) | Unit had no audio out, caused by defective D515 which isconnected between the AMP B+ line of IC503 (pin 6) and ground.Unfortunately, the service manual has no information of D515. -HQ COMMENTS: The part number for D515 is 8-719-921-98, typeMTZJ-T-9118. | ||
| Sony | CDX5060 | NO AUDIO (REPLACE DEFECTIVE D515, P/N 8-719-921-98) | Unit had no audio out, caused by defective D515 which isconnected between the AMP B+ line of IC503 (pin 6) and ground. | ||
| Sony | CDX5060 | EXPLANATION OF ERROR CODES NOT SHOWN IN SERVICE MANUAL | Is there a list of the error codes available for the abovemodel? How about other models? -HQ COMMENTS: The list of error codes for this model is limited, andunfortunately the explanations are not very descriptive. The only errorcodes we know about ar |