Dicas Reparação
Modelo - Chassis CDPC50
Pesquisa: CDPC50 Enviar Dica Resolvida
Resultados 36
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDPC500 | WIRE HARNESS IS TOO SHORT | Regarding service bulletin HFP0127, part number 1-946-072-21yields an eight-pin harness about four inches long, whereas this unitrequires a harness about twelve inches long. -HQ COMMENTS: Will fax Tokyo. To Tokyo: Should harness be longer? Isthere a l | ||
| Sony | CDPC505 | NO OPERATION - IC-102 IS DEFECTIVE | The lands to IC-102 on this unit become weak as the defectivechip heats up. They often lift or break. Some boards need to bereplaced. | ||
| Sony | CDPC500 | COUNTER NOT READING CORRECTLY | While playing a disc, the counter would not count correctly.For example, the display would jump from 1:00 to 1:42 and then pause.Meanwhile, the audio would play normally. When the disc got to that timespot, the display would jump again. AMS function al | ||
| Sony | CDPC500 | PART NUMBER FOR MAIN BASE UNIT | I need the part number for the main base unit, page 20 of theservice manual. Unit was put near something very hot, and this warped. -HQ COMMENTS: To Tokyo: Please supply us with the part number for themain chassis of this unit. Thank you for your coo | ||
| Sony | CDPC50 | MOTOR ASSEMBLY SPINDLE | The spindle motor is mounted in reverse polarity. | ||
| Sony | CDPC50 | SLED MOVES IN AS IT SEARCHES | When disc inserted, sled moves in to limit switch but does notcome out to read TOC. If you try to manually move sled out, it continuesto move back to limit but the motor drive is not continually on. It stopswhen sled contacts limit switch. | ||
| Sony | CDPC50 | PART NUMBER FOR REAR FOOT - REFERENCE NUMBER 35 | The original part number (X-4922-505-1) for the Rear Foot(reference No. 35) gets substituted to part number X-4922-508-1. Thisfoot is too large in size. It is the size of the front feet of the unit.We need the correct part number. -HQ COMMENTS: The re | ||
| Sony | CDPC50 | BROKEN PULLEY CHUCKING | I have found the Pulley Chucking broken in several units. Ihave replaced the Pulley Chucking and on a few units they have come backin a few weeks with the same problem. I found by melting and spreadingout center of the Pulley Chucking so it overlaps th | ||
| Sony | CDPC500 | INCORRECT PART NUMBER | The part number in the service manual on page 20 shows thestep screw with the part number 7-685-666-79. This part number comes upas a standard thread black screw. The correct part number is needed. -HQ COMMENTS: Tokyo has supplied the correct part num | ||
| Sony | CDPC50 | REPLACEMENT FRAME ASSEMBLY FOR CDP-C50 | Support post for gear (Loading C) is not part of replacementframe assembly. The frame requires replacement when the post holding partNo. 61 set lever breaks. Rather than undergoing the monumental task ofreplacing this entire assembly, only to have to m | ||
| Sony | CDPC500 | OPTICAL ASSEMBLY BRACKET | Page 20 of the service manual (see the unidentified bracket)surrounded by reference numbers 107, 106 and 120. Service bulletin No. 31indicates the part number is 4-924-445-01. An ASC received the part andclaims the tabs on the right side of the drawing | ||
| Sony | CDPC500 | OPTICAL ASSEMBLY BRACKET | Page 20 of the service manual shows the unidentified bracketsurrounded by reference numbers 107, 106 and 120. Service Bulletin No. 31indicates the part number is 4-924-445-01. An ASC received the part andclaims the tabs on the right side of the drawing | ||
| Sony | CDPC500 | TRANSIT KEY | Need part number for new style transit key. -HQ COMMENTS: The part number for the transit key is 4-930-510-01. | ||
| Sony | CDPC50 | SERVICE BULLETIN NUMBER HFP0040 | C-560 and R-593 in the above service bulletin refers to theCDP-C5F. What are the component numbers for the CDP-C50? -HQ COMMENTS: The circuitry in the C50 is obviously different. We donot have waveform shaping components here. Please check the photo | ||
| Sony | CDPC50 | PART NUMBERS NEEDED | We need part numbers for the following which are on page 20 ofthe service manual:B Down switch boardA Up/open switch board -HQ COMMENTS: These part numbers are listed in the CDP-C20/C26 and C30service manuals. The part number for the Up/open switch boa |