Dicas Reparação
Modelo - Chassis CCDV8AFU
Pesquisa: CCDV8AFU Enviar Dica Resolvida
Resultados 112
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV8AFU | CAPSTAN MOTOR WILL NOT START IN REVERSE DIRECTION / RPL C414 | The capstan motor will not go in reverse mode. Found highlevel ripple on audio 5 v lines caused by shorted C414. Apparently shouldnot cause capstan propblems. | ||
| Sony | CCDV8AFU | IC501 GETTING HOT DRUM SPEED ERRATIC/REPLACE Q508 | During playback or camera rec drum does not get on speed.IC501 gets hot and unit shuts down. Flashing eject LED appears. | ||
| Sony | CCDV8AFU | CAMERA POWER ON-OFF PROBLEM | Camera switch does not function intermittently comes on whenbattery is put in. It then will not shut off. | ||
| Sony | CCDV8AFU | VIDEO GOOD BUT EVERYTHING PURPLE | Luminance good but everything is a shade of purple. Good sig-nal on TP-705, ME-1 board. Bad signal on TP-707. Problem would clearwhen RV-701 turned to open side. | ||
| Sony | CCDV8AFU | EATS TAPE DURING EJECT | Eats tape during eject. IC-502 pin 15 not going to normal 4volts. Capstan motor would not turn except after a nudge to start it.IC-502 pin 10 input 150usec. pulse normal as read at turn on. | ||
| Sony | CCDV8AFU | NO POWER UP OF CAMERA SECTION | Camera section would not power up. Found DC-DC converter bad.Replaced DC-DC converter camera would power up for just a second then shutdown. Measured 5 volt line with Ohm meter (5 line measured 4 Ohms toground). Traced it down to shorted C-741 on ME-1 | ||
| Sony | CCDV8AFU | NO POWER ON CAMERA | No power on camera mode. Check pin 2 of CN-702, short toground. | ||
| Sony | CCDV8AFU | UNIT DOES NOT TURN ON WITH THE POWER SWITCH | The unit does not turn on with the camera power switch.Capacitor C-731 on the 20 volt line of CP-9 board was shorted. | ||
| Sony | CCDV8AFU | NO A/V PB, CAM REC, AUDIO E-E, FF/REW AND SLOW EJECT | 1) When eject it takes 7 seconds to start unthreading. 2) NoCAM REC audio EE. Picture ok. 3) No video and audio PB. 4) No F/F andrewind but Cue/Review is ok. Found pin #36 IC-102 (VI-6 Bd.) only 3V,normal should be 4.9V. Traced 3V came from IC-401 pin | ||
| Sony | CCDV8AFU | NO PICTURE AND SOUND IS NOISY | No picture and sound is noisy. | ||
| Sony | CCDV8AFU | PART UNABLE TO FIT | Replacement part will not fit - input cable too short.Measures 2 1/2 inches should be about 4 inches (3P connector) stock fromKC. -HQ COMMENTS: We are investigating and will advise. | ||
| Sony | CCDV8AFU | NO CAMERA FUNCTION | No camera function. We found no 5V from DC to DC converter.This measured 100 OHMs to ground. Further tests leveled C-709 to measure100 OHMs. | ||
| Sony | CCDV8AFU | NO CONTROL PANEL PART NUMBER FOR COMPLETE ASSEMBLY | Reference number 105 does not include buttons - need completeassembly. -HQ COMMENTS: Please order X-368-677-21 for the complete assembly. Aservice bulletin will be issued shortly. | ||
| Sony | CCDV8AFU | DOTS ON TAPE WITH OUTDOOR SHOOT ONLY | Leaves dots on tape like water spots on imager (outdoor only).Problem also occured with unit serial No. 24500. | ||
| Sony | CCDV8AFU | INTERMITTENT SHUTDOWN | VTR would either go off or turn on intermittently. This tran-sistor was leaky, causing the flip-flop to change state at random. |