Dicas Reparação
Modelo - Chassis CCDV5000
Pesquisa: CCDV5000 Enviar Dica Resolvida
Resultados 38
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV5000 | NEW AUDIO/PCM PC BOARD VERSION INCOMPATIBILITY/SM SUPP-1 | Instead of PC-35, we found a different version PC-52, withcustomer complaint as huming noise as in manual mode, even with and levelcontrol at minimum setting (0) level. The circuit is different withPC-35. Replaced with PC-35 that solved the hum. All a | ||
| Sony | CCDV5000 | NO COLOR GAIN | Weak, light color no yellow color only. If view with colorbar test chart no AWB or manual white balance function. | ||
| Sony | CCDV5000 | DISPLAY FLASHES | Display is ok in Stop mode. Switch power to VTR mode anddisplay starts to flash (as if no lithium battery). No noticable currentdraw on external power supply. | ||
| Sony | CCDV5000 | DATA SCREEN SCRAMBLED ONLY IN VTR WITH NO SIGNAL | CV-401 AFC trimed will correct data screen then it would startto drift. Voltages around IC-406 AFC capacitor pin 37 and up areincorrect. AFC input is UCC. Replaced CV-401. -HQ COMMENTS: CV-401 is the AFC adjustment element for the DDS SyncGenerator I | ||
| Sony | CCDV5000 | LCD FULLY LIT UP - INTERMITTENT | Sometimes by squeezing or flexing the cabinet all segments ofthe LCD would go on or sometimes the deck would even go into Rewind. Ifthe unit was disassembled, it would not fail. I notied that one cabinetscrew would connect the handle bracket (Ref. No. | ||
| Sony | CCDV5000 | UNIT MUST BE DISASSEMBLED TO ADJUST EVR | Unit needed EVR adjusted several times to satisfy a very de-manding customer. Unit had to be disassembled each time adjustments weremade to ground TP B6. | ||
| Sony | CCDV5000 | NO AUDIO - ONE OR BOTH CHANNELS | No audio output on left channel. Traced to no output but goodinput to audio output selector IC-317. Found C-382 had one lead pulledout of can. Noticed that all four capacitors along side of IC-317 werenot flush mounted to board. | ||
| Sony | CCDV5000 | "WAVY" LINES AT 2-4 SECOND INTERVALS IN PB WHEN RECORDED | After 30 minutes, Playback would show slight wavy lineshorizontally at 2 - 4 second intervals. This problem only exists on tapesrecorded on this unit. Playback of tapes from other units were perfect. | ||
| Sony | CCDV5000 | PART NUMBER FOR REC PROOF SWITCH TAPE SELECT | There is no part number listed for the REC proof switch onthis model. What is the part number? | ||
| Sony | CCDV5000 | CHANGE OF VIEWFINDER TYPE | Regarding the above CRT for the CCDV5000 viewfinder, has thisCRT been changed from a square type to a round type? A servicer says heopened a viewfinder to replace the CRT and noticed it had a round typeinstead of the square type. Has it been changed? | ||
| Sony | CCDV5000 | IMPROPER IRIS OPERATION WHEN IN MANUAL MODE | When switched to manual mode, iris would close completelyunder lower light conditions. | ||
| Sony | CCDV5000 | INCORRECT PART NUMBER FOR AF-DM ASS'Y | The part number listed in the manual for the AF-DM ass'y isA-7030-171-A. This part number is no good in KCP or RPC. | ||
| Sony | CCDV5000 | NO AUDIO FOR 1 1/2 SECONDS AFTER PAUSE | When customer takes unit out of pause mode, he has no audiofor 1 1/2 seconds. This causes a problem when editing. -HQ COMMENTS: This is normal operation. The audio must be muted untilthe servos come up to speed, otherwise there would be noise from the | ||
| Sony | CCDV5000 | WHEN USING DIGITAL FUNCTIONS OVERLAP NOT SMOOTH | When in Standby mode, picture will jump when going fromdigital functions to clear. When using the overlap function, afteroverlap is completed, picture will jitter slightly. Checked adjustmentsto digital board and found them in specs. Jitter of picture | ||
| Sony | CCDV5000 | OUTDOOR TOO RED AUTO SLIGHTLY OFF RED | After performing white balance adjustments, found outdoorpreset to be slightly red. Is there a way to compensate for this withoutaffecting the manual white balance setting? -HQ COMMENTS: The white balance adjustment should work OK. Please tryre-perfor |