Dicas Reparação
Modelo - Chassis CCDTR5
Pesquisa: CCDTR5 Enviar Dica Resolvida
Resultados 146
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDTR5 | DRUM REVERSES AND UNLOADS TAPE | When in rewind, drum reverses. When loading the drum slowsdown, then the tape is unloaded. The unit first came in with multipleproblems from an authorized servicer. The above problem occured when theVS-22 board was replaced. | ||
| Sony | CCDTR5 | TRANSPORT NOISE IN FF, REW AND PLAY | Conversion gear (No. 353) had too much play on shaft and wasintermittently hitting relay belt (No. 367) causing grinding noise. | ||
| Sony | CCDTR5 | DISTORTED PICTURE - LOSS OF SYNC | Unit had distorded picture and loss of sync that looked some-what like one head clogged. Had poor Playback Y+C at IC-203, pin 56.Had good Playback Y at IC-203, pin 23. | ||
| Sony | CCDTR5 | INCORRECT PART NUMBER (IC 503) | Part number should be 8-752-031-01. See page 234 of theservice manual. -HQ COMMENTS: The correct part number for IC-503 on the VC-60 board is8-752-031-01. | ||
| Sony | CCDTR5 | VERTICAL JITTER | On playback picture was jumping - vertical would not lock up. | ||
| Sony | CCDTR5 | POOR VIDEO IN PLAYBACK | Drop out in RF playback envelope (one of four missing).Appears to be tape path or head problem. | ||
| Sony | CCDTR5 | WILL NOT CLOSE DOOR OR LOAD TAPE | Unit will not close door: Use mode selector and manuallyclose door. When applying power, mechanism ejects ok but will notset back to load/unload state. Checked cassette lock switch and circuitlooked ok. Found dirty mode switch. | ||
| Sony | CCDTR5 | EATS TAPES | Unit eats tapes. The press-fit pins that hold the cassetteholder block assembly to the LS chassis had come out. | ||
| Sony | CCDTR5 | LOW LUMINANCE ON SELF-RECORDED PLAYBACK | Distorted picture on playback of self-recorded tape. | ||
| Sony | CCDTR5 | DOOR WILL NOT CLOSE | The TP arm block assembly (page 215, reference number 175) hadcome out of unit. The T protector assembly was bent. Replaced theseparts (including washers and joint bar). Unit would close and start toload. Then unit would jam due to misalignment of TP | ||
| Sony | CCDTR5 | CAMERA WILL NOT LOAD | Camera will not load. This is the second camera with this. | ||
| Sony | CCDTR5 | LOW LUMINANCE ON PLAYBACK | Unit had low luminance level when playing tapes recorded withthis machine prerecorded tapes played fine. Pin 24 of IC503 had luminancelevel of about 1 volt. pin 25 level was 0.6 volts. | ||
| Sony | CCDTR5 | INTERMITTENT CAUTION LIGHT | Found that unit loaded, recorded but on Playback (after zeromemory of about 10 minutes) picture was all snow except a dark 1 inch lineat top. After further inspection found that guides would not load arounddrum causing tape to ride up pinch roller. Uni | ||
| Sony | CCDTR5 | CASSETTE COMPARTMENT WILL NOT RELEASE | Post that holds cassette compartment latch is loose. locatednear No. 165 on LS chassis. The post is mounted on the LS chassisassembly. -HQ COMMENTS: Replace the LS chassis assembly: part number X-3727-953-2. | ||
| Sony | CCDTR5 | HORIZONTAL JITTER | Most of those units exhibit a subtle, but objectionablehorizontal jitter on playback. Any fix? -HQ COMMENTS: No there is no fix for this jitter. This is normalbecause of the smaller drum of the FL mechanism. However, if the problemis excessive then |