Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDTR4 | WRONG PART NUMBER IC-610 "VC-84" BOARD | IC-610 IC listed as part number 8-752-335-65 is incorrect. | ||
Sony | CCDTR4 | TICKING NOISE FROM MECHANISM | Heard ticking noise coming from the mechanism in all modes. | ||
Sony | CCDTR4 | VIEWFINDER STAYS ON | In the Camera mode with the Standby switch in the offposition, the viewfinder remains on. | ||
Sony | CCDTR4 | NO VIDEO IN CAMERA OR PLAYBACK | When in camera mode or VTR mode, there is no video in view-finder or video out. | ||
Sony | CCDTR4 | CAPSTAN ERROR | Using the RM-95 and looking at last fault it showed 00:04(capstan error). Mr. Takesue informed me he has seen 3 or 4 with thisproblem and it turns out to be the flex connectors (pins 1 and 2). Itseems that the pins are pushed down where their not makin | ||
Sony | CCDTR4 | INTERMITTENT CAUTION LIGHT | Traced to sticky white guide roller. | ||
Sony | CCDTR4 | OLD CASSETTE HOLDERS | Part number X-373-980-71 according to service bulletin numberCAM0221 dated 5/31/91, all the old cassette holders have been replacedwith new ones. I have ordered three from Kansas City Parts and receivedall old ones. Could you please check on this? I n | ||
Sony | CCDTR4 | NO PICTURE IN CAMERA MODE | No picture in camera mode. Checking CCD imager IC I found pin15 (V SUB) had 0 volts and Q-132 V sub regulator got very hot. FoundC-901 shorting V sub to ground. | ||
Sony | CCDTR4 | UNIT STAYS ON WITH SWITCH IN OFF POSITION | Unit works fine but when you turn the camera off, the viewfinder stays on also the pause and caution light. Cam is on and stayson. Found that there was a short between pins 5 and 6 on cable FP-330 onVS-70 board. | ||
Sony | CCDTR4 | EATING TAPES | The tapes are being eaten. | ||
Sony | CCDTR4 | INCORRECT PART NUMBER | |||
Sony | CCDTR4 | NO POWER | F-903 open - replaced and it opened again. Found short on VTRline C-522 shorted. | ||
Sony | CCDTR4 | ERROR IN SERVICE MANUAL | There is an error in the CCD-TR4 Service Manual page 250,section 8-2, Tape Path Adjustment. | ||
Sony | CCDTR4 | TAPE JAMMED | Found tape stuck in unit. After removal of LED base assembly,I found above part was bad. The gear had become separated from rest ofassembly. Part is enclosed for inspection. | ||
Sony | CCDTR4 | IRIS INTERMITTENTLY OPENS/CLOSES | Iris intermittently opens/closes. |