Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDTR100 | AFTER LANCING, E-E ALL BLUE (HAD TO SET ADD 2B DATA TO 58) | Unit was LANC'd and picture became blue in E-E. | ||
Sony | CCDTR100 | NO REC PIX (FOUND POOR SOLDER ON CN205 PIN 3 ON VS125 BOARD) | Camera had good E-E pix and playback but no record. | ||
Sony | CCDTR101 | NO FUNCTION POWER OK- IC924/VC103 | Unit was tampered with by other service dealer. Unit did notfunction, no camera or vtr. Found IC924 mode control ic bad The ic onlyinitialized reset, no power on vtr/camera on line. | ||
Sony | CCDTR101 | INTERMITTENT POOR EJECT/ M902 | When power is restored on vtr/camera, found mechanism problemon emergency mode. I can load and eject tapte but sometimes on eject, itejects out 2/3 then stops found capstan not turning. -SOLUTION :Replace a used capstan M902, restored unit to normal. | ||
Sony | CCDTR101 | NO COLOR IN CAMERA / RESOLDER IC301 | Color in pb but not e-e. | ||
Sony | CCDTR100 | NO PLAYBACK PIX / REPLACE C1167 ON THE HE19 BD | No playback pix, audio ok. | ||
Sony | CCDTR100 | NO AUDIO DISLODGED AU BD FROM THE VS BD. | Found audio board knocked from connector. | ||
Sony | CCDTR101 | CAUTION WHEN REPLACING VC OR VS BD / SEE SB295 | The VC board (1-642-225-13 and lower) and the VS board(1-642-224-13 and lower) are not available. If either of the -13 orlower boards need replacement you must replace both boards with, VCA-7063-087-B and VS A-7063-257-B. Both the -B boards are -14 andh | ||
Sony | CCDTR101 | STEADYSHOT JERKED SIDE TO SIDE; ADJUST ADDRESSES 12 & 13 | Steady Shot Jerky | ||
Sony | CCDTR101 | TDK TAPES GET STUCK | Tape stuck in unit won't eject. | ||
Sony | CCDTR101 | DEAD - X922/VC103 BD | |||
Sony | CCDTR101 | GRINDING NOISE RECORDED ON TAPE- GEAR ASSY | This gear had separated from its brass insert on the chassis,producing irregular motion which caused the belt to rub against its teethapprox. once every second. The noise was being picked up by themicrophone and recorded on tape. | ||
Sony | CCDTR101 | INTERMITTENT DEAD/RESOLDER IC924 | Camera section was dead, VTR section intermittent dead. | ||
Sony | CCDTR101 | CAMERA E TO E SNOWS AND DRUM RUNS TOO FAST/REPLACE DC-DC CON | Camers E to E is snowy and drum runs too fast. | ||
Sony | CCDTR101 | NO EVF VIDEO AFTER WARM UP/REPLACE Q304 | After 10-15 minutes of camera or VTR mode EVF video goes out. |