Dicas Reparação
Modelo - Chassis CCDF77
Pesquisa: CCDF77 Enviar Dica Resolvida
Resultados 35
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF77 | NEED PART NUMBER FOR THE DRUM BASE | I need the drum base for a CCD-F77. The manual shows it aspart of the drum assembly. It is not included when ordering the drumassembly. -HQ COMMENTS: A service bulletin will be issued on this soon. The partnumber is X-3686-482-5 and is in stock in KC | ||
| Sony | CCDF77 | WARNING LIGHT FLASHING | Warning light flashing intermittent or indicated eject flash-ing on. | ||
| Sony | CCDF77 | PART NUMBER FOR REC PROOF SWITCH TAPE SELECT | There is no part number listed for the REC proof switch onthis model. What is the part number? | ||
| Sony | CCDF77 | SCHEMATIC ERROR | Chappy from the Denver SSC reported a schematic error. Onpage 99 at IC-101, pin 16 shows the voltage to be +15vdc should be -9vdc.Pin 10 shows the voltage to be +9.4, should be +15. Page 104, pictorialshow the correct values page 99 is in error. -HQ C | ||
| Sony | CCDF77 | ERRORS IN SERVICE MANUAL | Errors in service manual on page 71 of Supplement No. 1:Section 4-5-17: Adjustment element should be CT-902, Section 4-5-18Adjustment element should be CT-901. Also on page 116 of service manual,the names of these two adjustment elements should be swap | ||
| Sony | CCDF77 | CAPSTAN RUN AWAY | Found capstan would intermittently run away. | ||
| Sony | CCDF77 | SERVICE MODE ERROR CODES ERRONEOUS | Old error codes were not erased from memory by previousservicer. This is contrary to instructions on page 58 of Supplement No.1 which states Be sure to rewrite the addresses from 20 to 26 to Data 00after the operation. This provided erroneous first (or | ||
| Sony | CCDF77 | TAPE PATH ALIGNMENT | Tape path entrance and exit out of alignment. | ||
| Sony | CCDF77 | RANDOM AUTOFOCUS AND ZOOM OPERATION | Random autofocus and zoom operation. Found missing data frompin 51 and 52 SCK on IC-501. | ||
| Sony | CCDF77 | NO PICTURE IN VIEWFINDER | No picture in viewfinder and found C-171 shorted. | ||
| Sony | CCDF77 | NO POWER OR DISPLAY | No power, display off, system control dead. This is thesecond unit with this problem. | ||
| Sony | CCDF77 | NO VIDEO IN EVF HAS RASTER | No video drive to pin 3 of CN-904 on the VF-26 board insidethe EVF. Note: I noticed a large amount of viewfinders on backorder toKC. I found two problems 1. a bad connection on CN-506 pin 8 of theVA-46 board 2. Bad transistor Q-171 EVF buffer also on t | ||
| Sony | CCDF77 | NO POWER | Only the display came on, nothing else works. Unit had noSS.5 volts. | ||
| Sony | CCDF77 | CCD-F77 ALIGNMENT PROCEDURE | There are many mistakes in the CCD-F77 alignment procedure.Will a bulletin be issued covering this? -HQ COMMENTS: A service bulletin will be issued describing thecorrections. See CSV-2 #198. | ||
| Sony | CCDF77 | INCORRECT ALIGNMENT PROCEDURE FOR HALL ADJUSTMENT | The alignment procedure for the Hall Adjustment (ServiceManual Supplement-1 page 29 step 3-3-6) does not work as indicated. -HQ COMMENTS: The correct procedure is as follows (ignore the procedurein the service manual): 1: SELECT ADJUST PAGE F ON THE REM |