Dicas Reparação
Modelo - Chassis CCDF40
Pesquisa: CCDF40 Enviar Dica Resolvida
Resultados 56
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF401 | LOW BATTERY ADJUST | I was informed by the technician in San Diego of a problem ofnot being able to do low battery adjust. The problem is if the unit isset higher than 5.58 VDC as called out in the procedure, the unit shutsoff and no display on the RM-95. This prevents you | ||
| Sony | CCDF401 | UNIT WILL NOT COME ON | Unit would not power on. Checked IN/OUT data on the VK-14board and found distorted data. Traced problem to shorted zener diodeD-517, (K-in 2 output). Checked another board and found no zener diodeson the data lines. It seems Japan eliminated the diod | ||
| Sony | CCDF40 | ONLY BLUE COLOR ON CAMERA MODE | When in camera mode, only blue color. | ||
| Sony | CCDF40 | NO RECORD OR PLAYBACK (PAGE 107) | No Record or Playback. | ||
| Sony | CCDF40 | DISTORTION IN PICTURE (PAGE 115) | Distortion in picture. In Playback picture looks like tapeentrance out of adjustment also sound was distorted. | ||
| Sony | CCDF401 | CAPSTAN MOTOR WILL NOT OPERATE IN RECORD, PLAYBACK OR EJECT | In Play, Record and Eject modes the capstan would not turn.In FF or REW, F Search or R Search it would turn slower than normal andIC-504 on the SS-136 board would grow warm. | ||
| Sony | CCDF40 | VIDEO ROLLS IN CAMERA MODE | Video rolls in viewfinder and monitor. | ||
| Sony | CCDF40 | INCORRECT PART NUMBER FOR IC-368 "VA-40" BOARD | The part number number for the above part incorrectly listedon page 153 of the CCD-F40 Manual. | ||
| Sony | CCDF40 | NO COLOR FROM CAMERA | No color in E-E mode from camera. Color entering IC-364 pin 1but nothing out of pin 7. There was also no record color. Unit did play-back pre-recorded tapes ok. | ||
| Sony | CCDF40 | NO CAMERA OR PLAYBACK VIDEO OUT | Unit had no camera, playback or EE video. Signal was goodgoing into input select IC-362 pin 28. (VA-40 Board) Video looked clippedat pin 11, and no signal was present at pin 4. Changing IC-362 had noeffect. Found no serial data I/O at pins 20-23. Tr | ||
| Sony | CCDF40 | (CHARACTERS ROLL IN VIEWFINDER) MONTH, DATE, YEAR - PIX OK | Intermittently, date, month and year out of vertical sync onviewfinder display. No vertical sync pulse to pin 13 of charactergenerator IC-367 on VA-40 board. | ||
| Sony | CCDF40 | UNIT POWERS UP BUT DOES NOT ACCEPT ANY COMMANDS | The unit powered up ok but did not accept any of thecommands. There was no VTR power signal going to the DC-DC converter.The VCR power signal was present at pin 35 of IC-001, but it was not atcollector of Q-079. Unregulated voltage was missing at the e | ||
| Sony | CCDF40 | NO TELE/WIDE OPERATION | There was no lens movement when the zoom switch was pushedfor wide angle. With the zoom switch pushed to the wide side, therewas not a low at pin 4 of IC-200 of SS-86 board. There was an openingbetween W001 pin 5 (WIDE) and the resistor R-029 on the SS | ||
| Sony | CCDF40 | POOR FOCUS WHEN PANNING WITH TELEPHOTO | Objects will go out of focus on left and right edges in fulltelephoto when camera is panned left/right with autofocus turned off.This problem is evident in all CCD-F40s and lens replacement does notsolve this problem at all. Is there a defect in lens? | ||
| Sony | CCDF40 | POOR PLAYBACK | Playback picture on TV monitor displayed bad heads, but RFenvelope looked good. Traced signal to soft limiter circuit where RFentered but left distorted Q-376, 378 and 379 had no 5V supply. |