Dicas Reparação
Modelo - Chassis C9
Pesquisa: C9 Enviar Dica Resolvida
Resultados 312
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Thomson | ICC9 37MG73J | Pic break up with folded horiz lines at bottom half | RF11 safety res 1R5 o/c pt no 15022560 | ||
| Thomson | ICC9 37M973J | service mode entering | Switch on holding in Blue Txt button then press blue button again | ||
| Thomson | ICC9 37M973J | E-W bowing | IV01 STV2160 replaced & uprate CV46 from 10nF to 22nF sm; RL45 3R3 o/c, LL08 pt no 10092690, CL42 4µ7 160v | ||
| Thomson | ICC9 | Trips on & off aft 1 min | OK when you s/c TR96 sm st/by tr - TV92 sm was the cause even tho it check ok out of cct | ||
| Lowe | C9003 | Relay on front PCB energized but volts at PSU main Cap <300V (No start up as there is <7v to TDA 4601 | Relay on Front panel is defective, it make contact only briefly (you cannot turn the set on by s/c relay contacts ) | ||
| Lowe | C9000 | Field - lack of height | 27v supply low, C656 2200µ35v & T658 BD139 | ||
| Lowe | C9000 | Dead | fusible link R504 o/c & 315mA fuse in LOP o/c - LOPTx | ||
| ITT | CVC9 | Sound - loss of sound. | VDR R409 use a VA8650 from wVe. | ||
| Grundig | CUC95 | No pic, heaters or EHT - no line pulses from TDA1950 | EHT cap had been arcing and caused demise of TB chip TDA1950 & TDA1770 field chip | ||
| Grundig | CUC95 | Field collapse | all 3 field pre-set pots had been twiddled & broken - replacement cure | ||
| Grundig | CUC95 | FIELD COLLAPSE | R2754 1M PRESET | ||
| Grundig | CUC95 | Dead - BU208 s/c. | R646 high. | ||
| Goodmans | GD2880A ICC9 | TV works ok but LED red not Green | TR28 BC858B sm s/c | ||
| Goodmans | GD2880A ICC9 | St/by only | TP66 BC858B sm | ||
| Goodmans | GD2880A ICC9 | Int dead | Volts around TR85 BC848B & TR87 BC858B incorrect - Trs faulty |