Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDPC85ES | INTERMITTENT SHUT DOWN - REPLACED D913 | Unit would play perfectly for a time. 5 mins to severalhours. When in failure mode, laser would return to home position andun-chuck the disc. CLV motor may also spin rapidly. | ||
Sony | CDPC89ES | INTERMITTANT DISC SKIP, TRAY ALWAYS ROTATES - ROLLERS FLAT | The unit is continuously spinning the tray or intermittentdisc skip. Troubleshooting, I found that the rollers for the tray wereworn flat. The flat rollers prevent the mech. control from identifyingthe disc location. | ||
Sony | CDPC89ES | MECHANICAL NOISE DURING OPEN/CLOSE/DISC SKIP - ADJ BRACKET | When units press open/close or disc skips it would make aclick click mechanical noise. As soon as I took the cover off, I saw thatthe bracket (press pulley) was set too low. When the tray turned, thebracket and tray contacted each other. | ||
Sony | DTC87ES | INTERMITTENT STATIC IN AUDIO - CN351 IMPROPERLY SEATED | When playing back or recording analog, the meters were pegged. | ||
Sony | CDPC87ES | NO AUDIO/NO DISC TABLE ROTATION (REPLACE R340, Q-210) | The disc tray would not rotate. When you placed the discmanually into position, disc TOC was read and the disc played but therewas no audio output. | ||
Sony | CDPC85ES | NEW DISC TABLE FROM KCP HAS ONE HOLE PER DISC INSTEAD OF 2 | I ordered ref. No. 53 disc table (P/N 4-726-383-11) andreceived one with only one small hole and a slot instead of two holes. Ithen ordered No. 69, A-4604-533-A disc table assembly which included adisc table with two holes per disc. | ||
Sony | TC818M | NO FUNCTIONS/BROKEN PC BOARD | This is the deck section of the MHC-3300. No tape functions.Caused by cracks around Q-704 and Q-702 on Audio board. Board has pre-forations at this point, presumably to aid heat transfer. This weakensit. Sample to follow labeled KV0501. -HQ COMMENTS | ||
Sony | EVC8 | CHEWS TAPE INTERMITTENTLY | Unit will chew tape, highly intermittently. Found the greaseon the shaft of the B gear assembly to be very sticky. It seems that asthe unit ages the grease thickens and restricts the rotation of the gear. | ||
Sony | CDPC85ES | TORN PRINT ON PCB | When you remove IC-102 with Pyro pen, too much glue has beenput underneath IC. When you try to remove the IC, the print tears up thecircuit board. -HQ COMMENTS: The glue used is necessary during the manufacturingprocess to secure the components to the | ||
Sony | CDPC85ES | DISC SPINS DOES NOT READ TOC | A new A stock unit the Laser is firing, disc spins, but theinformation is not being read. A very poor RF pattern is observed whenthe player is trying to read TOC. The lens is popping up and downapparently trying to focus and the motion of the lens is r | ||
Sony | CDPC85ES | DISC TABLE WILL NOT ROTATE | On some units the bracket which houses the optical devicecontacts the base of the player. This causes the table not to rotate orthe disc not to play. -HQ COMMENTS: The cause of the problem is the metal base warping upward.When the bracket drops it does | ||
Sony | EVC8 | RECORDING COLOR IS BAD | Unit was recording with no green component (color bar). | ||
Sony | CDPC800 | PART NUMBER NOT LISTED FOR CHASSIS | There is no part number listed for the Chassis Assembly, shownon page 27 of the S/M. It is listed as NOT SUPPLIED. Do I have toreplace this unit to resolve this problem? -HQ COMMENTS: Let me see if I can get a part number for this.To Tokyo: Can you su | ||
Sony | TC818M | WOW AND FLUTTER ON RECORD | Wow and flutter on record. Sometimes noticeable on playback. | ||
Sony | EVC8U | SNOWY PICTURE EVERY TWO OR THREE SECONDS | Every 2 or 3 seconds the picture would become snowy. Soundremained OK. |