Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | BMC550 | NO AUTO FOCUS | Unit came in with complaint of no auto focus. After extensiveelectronic troubleshooting and adjustments I noticed that the push rodthat is activated by the lens barrel to give mechanical reference to theinfrared transmitter did not move when lens moved. | ||
Sony | BMC550 | POOR PAUSE EDIT (GAP BETWEEN RECORDINGS) | When operating record pause the recorded video has a long gapbetween the recordings. The gap at this edit point is long enough attimes for the video that was previously on the tape to be seen when thetape is played back. Found that the reel brakes were | ||
Sony | BMC550 | NO VIDEO | No video record, audio OK. | ||
Sony | BMC550K | BETAMOVIE TURNS ON IN REC MODE | With a tape in unit at turn on, unit would go into record modeand would not come out. | ||
Sony | BMC550 | HOOK UP OF THE BMC-550 AND THE BMCJ-888U CONVERTER | In Fig. 1-7 on page 133 of the S/M the 4 pin connector fromthe converter is shown connected to the 5 pin connector on the CS-5 board,what are we to do? -HQ COMMENTS: The Betamovie jig cannot control the BMC-550operations. Although inconvenient, you mus | ||
Sony | BMC550 | SKIPS ON PAUSE | Glitch on picture. | ||
Sony | BMC550 | UNIT GOES INTO SHUTDOWN EIGHT SECONDS AFTER TURN ON | After cassette was loaded and threaded, unit would shut offand DEW LED would lite. Found the drum speed adj. was intmtly varying. | ||
Sony | BMC550 | SERVICE MANUAL CORRECTION | Adj. 2-3-9 should read RV807, RV808. Adj. 2-3-10 should readRV809, RV810. MR1-MB1 temp adjustment CV-1 board. MR2-MB2 tempadjustment CV-1 board. -HQ COMMENTS: We will issue a S/B. | ||
Sony | BMC550 | NOISE IN AUDIO ON QUIET SCENES | Customer complains about background noise from auto focus andmechanism. CS-5 board changed. -HQ COMMENTS: Due to the proximity of the microphone to the focus andzoom motors, acertain amount of noise is unavoidable during quiet scenes.Reducing the gain | ||
Sony | BMC550 | DRUM ASS'Y | The S/M of BMC-500 unit gives the same part number as well asfor the BMC-110. But they are different, cannot be mounted properly onthe A-6050-209-A. The opening is much smaller and will not go over thescrew holding the track which the threading ring ri | ||
Sony | BMC550 | PART NUMBER FOR HANDLE SCREW | We need the part # for the thumbscrew which attaches thehandle to the necessary shoe on top of the camera. The part number forthe handle is 3-691-167-01, listed under accessories at the rear of themanual. -HQ COMMENTS: The handle is not available as an | ||
Sony | BMC550 | PART NUMBER FOR IMAGER | BMC-550 IRP 8-750-010-22 What is correct P/N for BMC-550 S/M 8-750-010-22 CCD-V8? We do not know and CCD-V8 IRP 8-750-010-22 have no stock of S/M P/N. CCD-V8 S/M 8-750-010-22 -HQ CO | ||
Sony | BMC550 | INCORRECT P/N PAGE 148 | Typo in manual, Page 148. -HQ COMMENTS: Correct P/N SK-3 board (complete) A-7060-078-A DS-10 board (complete) A-7060-098-A DS-10 board part number is correct on Page 175 in the S/M. | ||
Sony | BMC550 | REPLACEMENT NUMBERS FOR CR2025 BATTERY | Since we do not have sample CR2025 battery, can you advise theDuracell or Eveready replacement numbers? -HQ COMMENTS: The numbers are as follows: SANYO CR2025 DURACELL DL2025 | ||
Sony | BMC550 | LITHIUM BATTERY | One customer has lost lithium battery already one customerbattery was missing from carton and one wants to purchase replacementjust to be on the safe side. |