Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sharp | CS 59/66CS03H | trips, no pic or sound, but bright light on top of screen with random colours | Q707 BC338 o/c in "all time" 5V supply | ||
Sharp | CS 59/66CS03H | stuck in stby | Q704 BC338 o/s | ||
Sharp | CS 59/66CS03H | sound Ok, no pic. Flyback lines visible if A1 turned up. | R640 180R fusible s/c (RRXZ227BMZZ) | ||
Sharp | CS 59/66CS03H | slow to come on | C712 220uF 25V | ||
Sharp | CS 59/66CS03H | slow start from cold, NICAM LED is on | C714 1000uF 10V 105degree | ||
Sharp | CS 59/66CS03H | poor focus (looks like CRT faulty) | R618 22k gone high | ||
Sharp | CS 59/66CS03H | no teletext | no video on pin 10 IC401 due to Q451 2SA1037 and Q901 2SC2412 leaky. | ||
Sharp | CS 59/66CS03H | no sound, pic Ok | Sound muted by Q314, Q313, Q315 not getting +40V supply from line stage, R643 5.6R o/s. These components are not market on CCT, instead refer to CCT of 51CS03H | ||
Sharp | CS 59/66CS03H | no response to remote or front buttons | D1101 (RHEX0545BMZZ) s/c, no supply to pin 1 IC1010 | ||
Sharp | CS 59/66CS03H | no pic, no sound, set tripping | R628 getting hot, 45V supply down to under 10V due to Q704 BC338 s/c (+5V standby and sound supply) | ||
Sharp | CS 59/66CS03H | no line drive, red and green LEDs on, all secondary volts Ok | R740 330k 0.25W o/c (no volts on pin 15 IC1010) | ||
Sharp | CS 59/66CS03H | int. dead, LOPTr runs hot and blows after a few days | poor connection on scan plug on scan coil (not pushed fully to locked position) | ||
Sharp | CS 59/66CS03H | frame collapse | no 5V supply, replace Q707 BC337 and R643 5R6 0.5W | ||
Sharp | CS 59/66CS03H | field bounce and then field roll on text only | C604 330uF 10V | ||
Sharp | CS 59/66CS03H | dead, no green LED, only neon | audio stage s/c shorting +16V and -16V rails. Replace D305, D306, D307, D308, Q305, Q306, Q311, Q312 |