Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sharp | DV5103H/DV5903 D3000 | Chrom info out of register with lum | Small plug in non volatile memory chip IC1411 on digital PCB | ||
Sharp | D3000 DV6603H | clicking noise from speaker, gets worse when warm | replace IC0302 RHIX1433BMZZ | ||
Sharp | D3000 | Shuts down int | R628 1k & R746 22k hi res | ||
Sharp | D3000 | Faint pic after loptx replacement | C606 0µ22 between pins 6 & 7 of loptx leaky | ||
Lowe | E3000 | Attempts to start but goes into prot mode (not st/by) | Dis HT from LOP stage restores HT - BA157, feeding the 27Volts, from the loptx was shorted, | ||
Loewe | E3000 | Dead - burnt comps in psu | D630 22R, D630 gp sw diode | ||
Finlux | 3029V 3000 | Dark bars across top of picture plus cramping | Ck8 ( 0.1uf ) o/c , Cz14 ( 4.7uf , 250v ) . | ||
Finlux | 3029 3000 | Line spacing at bottom of screen. | CK8 ( .1uf , 63V ) small white square under frame o/p IC heatsink. | ||
Finlux | 3000 srs | NO TUNING IF FINGER PRESSED ON PIN 18 SDA3202 TUNE | REPLACE SDA3202 | ||
Finlux | 1000/3000 | Dead | BY299 17v rect or Du16 138v HT rect | ||
Finlux | 3000 | Vertical sync int absent | TDA 2450-2 u/s. Use Kit TDA 2450 | ||
Finlux | 3000 | St/by only | Eeprom faulty - EEPROM is programmed - empty one can not be used. | ||
Finlux | 3000 | St/by only | Cu7 & Cu8 100µ 35v | ||
Finlux | 3000 | SNOW ON SCREEN | CHECK 30v FEED Ri37 Ri39 | ||
Finlux | 3000 | PICTURE SHIFTED TO RIGHT | Rz19 IN LINE OP STAGE 27k |