| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Toshiba | 28W23B 11AK37 | Picture displaced vertically, picture too high or low | This problem was cured by entering the service mode menu then 4,7,2,5, then pressing the green fastext button to access geometry settings, selecting VP1 vertical position and adjusting as necessary | ||
| Toshiba | 28W23B 11AK37 | Procedure to enter the service mode | Press the menu button then 4,7,2,5 | ||
| Toshiba | 28W23B 11AK37 | St/by only - trips off at sw on | LOPTx | ||
| Toshiba | 28W23B 11AK37 | Service mode entering | Press "Menu", then 4, 7, 2, 5 - to set geometry press Green fastext button | ||
| Toshiba | 28W23B 11AK37 | Dead - off with a bang | IC800 pt no V30011968, Q801 V30001386, C860 V30000107, D892, 896 BA159, R805 & 852 33R 1/2w, Fuse F801 2.5A & check LOPTr BU2508AF | ||
| Toshiba | 28W23B 11AK37 11AK37 | St/by only - trips off at sw on | LOPTx | ||
| Toshiba | 28W23B 11AK37 11AK37 | Service mode | Press "Menu", then 4, 7, 2, 5 - to set geometry press Green fastext button | ||
| Toshiba | 28W23B 11AK37 11AK37 | Dead - off with a bang | IC800 pt no V30011968, Q801 V30001386, C860 V30000107, D892, 896 BA159, R805 & 852 33R 1/2w, Fuse F801 2.5A & check LOPTr BU2508AF |