Dicas Reparação
Modelo - Chassis 2580
Pesquisa: 2580 Enviar Dica Resolvida
Resultados 47
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sanyo | CBP2580 | The word "factory" in a red box is permanently displayed on screen and sound volume goes from 0% to 50% to 100% | Enter service mode, go down to nvm and press volume plus on remote | ||
| Sanyo | CBP2580A EB2 series | Tripping - even with psu on dummy load | black jumper wire which runs from the earth side of the chopper transformer to a point very close to IC351 a regulator IC, was dry jointed at the chopper transformer end. | ||
| Sanyo | CBP2580 EB125 | This set would shut down interrnittently: the peri | The set could be made to run indefinitely by entering the service mode ( menu on the set's control panel , followed by menu on | ||
| Sanyo | CBP2580 EB1 | To enter service mode | Menu on set's control panel, followed by menu on R/C handset | ||
| Sanyo | CBP2580 EB1 | Shuts down int - runs ok in service mode if IM bus run is stopped | Fault somewhere on the IM bus - NVM3060 EEPROM on digiboard cured fault | ||
| Sanyo | CBP2580 EB1 | Colour lost & pic shifted to right when heated | Xtal X403 pt no 610 217 1037 | ||
| Sanyo | CBP2580 EB1 | AFTER 2-3 Hrs COLOUR GOES AND PICTURE SHIFTS TO R | XTAL X403 DRIFTING Pt No 610 217 1037 | ||
| Sanyo | CBP2580 | St/by only - trips at start up | 22mfd 250v B+ decoupler s/c | ||
| Sanyo | CBP2580 | Int start up - EHT can be heard | Check for int mains switch | ||
| Matsui | 2580 2590 | DEAD OUTPUTS PRESENT ON SECONDARY SIDE OF CHOPPER | CHECK ALL VOLTAGE REGULATORS | ||
| Matsui | 2580 | Won't come on after psu rebuild | Tr803 BD139-16 in 24v reg o/c | ||
| Matsui | 2580 | To enter service mode | Hold down serv sw inside set & press chan button on handset. Press "Full" button to select from menu. For height press vol up/down. To store press "Normal" & then st/by | ||
| Matsui | 2580 | St/by only - int | D118 going o/c int | ||
| Matsui | 2580 | St/by only | HT rail varies between 78v - 175v with time. C808 1µ 63v o/c | ||
| Matsui | 2580 | PICTURE BREAKS UP ON CHANNEL CHANGE | IC1503 MDA2062 |