Dicas Reparação




Modelo - Chassis 14


Pesquisa: 14 Enviar Dica Resolvida
Resultados 8056
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCPD1425
BROKEN MAIN BOARD Dead, Main Board broken near flyback transformer. Damagecaused by hard plastic support bearing against weak spot on board.Unit bumped in normal handling causes a break in Main PCB.
SonyCPD1425
RESISTOR BODY SHORTED TO PCB RUN
SonyCPD1425
TESTED MONITOR PICTURE NOT SYNCHED No synch when connected to Team Video Gen. card. Foundproblem with extender cable, which works for all of our other monitors.Tried 6 different CPD1425's.
SonyCPD1425
LOSS OF SYNC WHEN USED WITH MAC, CAUSED BY TMAC ADAPTER Display shows a loss of sync when interconnected to MACcomputer via TMAC adapter. -HQ COMMENTS: TMAC adapter does not ground Pin 5 of monitor's Video Incable. This causes monitor to enter special test mode. To correctproblem, please recommend use of M
SonyBM146
R.F.I. CAUSES RECORD INHIBIT CKT TO ACTIVATE, INSTALL SHIELD R.F.I. was being picked up by the Record Inhibit head causingthe machine to drop out of RECORD mode. The source of interference couldnot be removed.
SonyCPD1430
WRONG PART FOR T901, CORRECT PART NUMBER IS: 1-423-3461-1 As listed in manual, it is the part number for T401 instead.These are not same transformer. Need correct part # for T901.
SonyEXR14
NO AUDIO/DISPLAY (FOUND D705 SHORTED) When turned on, unit had no display and would have audio forabout 3 seconds only. Found D705 shorted, keeping VDD from IC701.
SonyCPD1430
HORIZONTAL FOLDOVER IN THE PICTURE CENTER Both units came from the Bahamas, via Miami, and bothdisplayed same problem. Customer complaint is bright vertical line wasverified. Waveform at base of H out showed a glitch between pulses,therefore, problem appeared to originate at the driver or va
SonyXR4147
NO AUDIO, FOUND IC302 AND B+ TRACE PHYSICALLY DAMAGED IC302 shorts out and physical damage is apparent.
SonyEXR14
NO DISPLAY/NO TUNING (TAPE WORKS OK) Unit had no display, and only static on radio. The tape deckworked fine. Found D362 shorted, which also caused the trace between D362and pin 2 of CNP801 to open.
SonyCPD1430
Q406 PART NUMBER MISSING, 8-729-018-43 Part number for Q406 is not in part list of D boardtransistors.
SonyCPD1430
DEAD, REPLACED Q406 Unit is dead, power supply has high pitch squeal. Found D403shorted. Turned unit on and display was wide. Checked Q406 it was leaky.
SonyCPD1430
UNIT SHUTS DOWN IMMEDIATELY (ON POWER UP) Unit powers up, but immediately shuts down. Gate of FET(Q403) had only 25v instead of 144v.
SonyCPD1430
BLUE SCREEN AND SHUT DOWN, REPLACE Q506 C-BOARD Screen goes blue and unit shuts down. Q506 had an emitter tocollector short. -HQ COMMENTS: Q506 is the Background level Control Transistor. If itshorts as in this case, the Background level for the Blue gun becomesexcessive.
SonyCPD1430
NO PICTURE / DEFECTIVE IC-502 VIDEO AMP (VPS07-T) Unit would not display a picture. Cathode dc voltages wereOK. G2 was correct and filaments were lit. The dc voltage on pin 9 ofIC502 (C board) was 1.8 volts instead of 75volts (drive out).


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads