Dicas Reparação
Modelo - Chassis 11AK19
Pesquisa: 11AK19 Enviar Dica Resolvida
Resultados 335
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Mitsubishi | BDS28WS 11AK19 | Dead apart from LED dimly flashing green - will sw on & off - no EHT & HT (150v) low at 102v | D807 in psu leaky | ||
| Mitsubishi | 11AK19 | Dim band of light 3/4 up screen - sound ok | D408 8V2 zener leaky | ||
| JMB | JMB66W 11AK19Pro | Dead - LED lit green but no line drive | pin 40 TDA8844 s/c. There is an internal diode between pin 40 & ground that goes leaky, replace the IC or burn diode o/c by applying 5V between pin 40 & ground from ext psu | ||
| Hitachi | C2842N 11AK19PP | Dead - D823 blown (not shown on cct) | When replaced still faulty, IC802 MC44604P chopper chip u/s - also check FET chopper Tr | ||
| Hitachi | C2125T 11AK19Y4 | St/by only | Handset was faulty even though it gave an o/p | ||
| Hitachi | C2125T 11AK19K | Dead aft it went pop | D812 BYD33D s/c in 14v supply | ||
| Goodmans | GVT66W1 11AK19 | To enter service mode | Call up install menu then pres 4, 7, 2 & 5 in order | ||
| Goodmans | GVT66W1 11AK19 | Lack of width & E/W faulty | R629 2R7 1/3w safety res o/c | ||
| Goodmans | GTV69W3BLU4 11AK19pro | R629 value | 2R7 in 28" 4:3; 27R in 28" widescreen; 44R in 32" widescreen | ||
| Goodmans | GTV69W3 11AK19 | Switching from Nicam to Mono then no sound | VL301 on Nicam PCB | ||
| Goodmans | GTV66W1 11AK19B-1 | Width reduced & no E-W | C630, R629 2R7 and the BUK444 200A. | ||
| Goodmans | GTV66W1 11AK19 | Tripping | Audio O/P IC TDA2615 | ||
| Goodmans | GTV66W1 11AK19 | Narrow pic | C630 dry R629 2.7R burnt. Also replace D612 BY228 | ||
| Goodmans | GTV66W1 11AK19 | E/W dist | Dry joint C613 12nF, R629 27R safety res o/c, C630 390nF 250v low cap | ||
| Goodmans | GTV66W1 11AK19 | Dead - LOPTx s/c, when replaced, E-W errors | D611 (BY299) was leaky |