Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Bush | 2871NTX 11AK19 | Tripping - LOPTr BU2508AF s/c | Caused by scan coil plug on pcb arcing internally | ||
Bush | 2871NTX 11AK19 | Tripping | Check diodes D814/5/6 on sec psu for s/c UF5402 | ||
Bush | 2868NTX 11AK19-5 | Txt absent apart from "100" | Replace multi micro/text chip SDA5255-A047 available from cHS | ||
Bush | 2868NTX 11AK19-5 | No tuning - pic settings wrong | Replace with blank eeprom & set up with hex code | ||
Bush | 2868NTX 11AK19-5 | E/W faulty | C630 470nF | ||
Bush | 2868NTX 11AK19 | No pic - sound ok - pic will appear briefly when adj A1 | C604 47nF 63V s/c in beam current | ||
Bush | 2868NTX 11AK19 | Entering service mode | Select "Install" then key in "4, 7, 2 & 5" via hset | ||
Bush | 2868NTX 11AK19 | E/W correction faulty | Q683 FET BUK444 faulty | ||
Bush | 2868NTX 11AK19 | Dead with LOPTr s/c | Check conns to scan coil plug - if overheated, wire directly | ||
Bush | 2868NTX 11AK19 | Dead | R806 22k o/c also R825 2M2 o/c | ||
Bush | 2868NTX 11AK19 | Child Lock removal | go to the menu and toggle the child lock between on/off | ||
Bush | 2867NTX 11AK19 | Pic takes long time to appear - quicker if A1 adjusted | Check C608 10µ 250v reservoir cap for RGB stages by edge near LOPTx | ||
Bush | 2867NTX 11AK19 | No line drive | R866 0R33 in series with 14v supply o/c (not shown on cct diag) | ||
Bush | 2867NTX 11AK19 | Int off with smell of burning | dry joints chopper trfmr | ||
Bush | 2863NTX 11AK19E3 | Dead with HT of 16v - ok on dummy load | Supply to 5v reg missing - R867 0R33 o/c |