Dicas Reparação HITACHI
Modelo - Chassis C2864TN
Pesquisa: C2864TN HITACHI Enviar Dica Resolvida
Resultados 5
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Hitachi | C2864TN | Psu in slow trip. 630mA fuse on E/W panel blown | Top E/W diode leaky D704 BY228 | ||
| Hitachi | C2864TNZ | Slow or no start up | C909 470µ 25v | ||
| Hitachi | C2864TNX | Dead aft EHT rustle & led single blink at sw on | HT checked on dummy load at 170v (149v). Int set HT pot VR930; R509 1R 1/2w safety res by LOPTx o/c; IC800 RGB o/p chip & C821 4µ7 250v faulty also. | ||
| Hitachi | C2864TN | Slow tripping/partial field coll/blank raster/no sound | R609 1R fusible o/c - also replaced TDA8178 Field o/p IC as a precaution | ||
| Hitachi | C2864TN | Electronic screwdriver set up | Hold the vol + and - buttons and switch on. The set will come up with Factory 05 on screen. On the handset press the two rec keys twice(linked by white line) The set will display the tube menu. The top coloured adjustments correspond to the top coloured keys on the handset , the bottom coloured adjustments correspond to the bottom coloured keys. Push the coloured key on the hand set corresponding to the adjustment, ie VA for vertical Amplitude. VA will be high lit. Now pressing the Vol+ or - on the handset will adjust the value. To store the settings , press diamond shaped key (store) and put set into standby to exit service mode. You do not need to store each adjustment, you can adjust them all and store them once at the end. It is a good idea to jot down all the numerical values for all the adjustments first, so if you make a mess you can put the adjustments back to their original settings. |