Dicas Reparação TOSHIBA
Modelo - Chassis
Pesquisa: TOSHIBA Enviar Dica Resolvida
Resultados 4723
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Toshiba | 1400TB | Field non lin | Check C317 2µ2 50v & C303 2µ2 50v (behind 4.43 Xtal) | ||
| Toshiba | 1400TB | Chopper tfmr buzzing aft CRT change | Connect 330R ½w res across R814 | ||
| Toshiba | 1400RDT | Dead | STR50020 u/s; damper diode s/c & several resistors but LOPTx was faulty | ||
| Toshiba | 1400RBT/RBW | Field collapse | C303 2µ2 ramp gen cap leaky & C317 2µ2 in lin fb cct leaky causing vert centre fault | ||
| Toshiba | 1400RB | Tuning drift | Replace DA34 PtN 23115599 | ||
| Toshiba | 1400RB | Field lin dist | C317 (behind field chip) & C303 (behind if can) both 2µ2 & red | ||
| Toshiba | 1400RB | Field cramp / stretched at top | C303 2µ2 pin 13 IC501 jungle chip | ||
| Toshiba | 1400RB | Auto tune not locking on | Replace QA06 no AFT on pin 8 ICA01 or Replace QA16 no sync on pin 9 ICA01 PtNo 233114689 | ||
| Toshiba | 1400RB | 500mA fuse F803 in HT line blew int | 3 rubber wedges on crt conductive - scan coils arcing to them | ||
| Toshiba | all new sets | unable to get install menu | software glitch. Put into stby and then switch on using R/C (not on/off switch). Set will now perform normally | ||
| Toshiba | 2,14E+06 | Set dead StBy LED goes out when R/C pushed but set | C815 ( 0.039uF ) | ||
| Toshiba | 2,12E+06 | LOW , DIST SOUND | D632 | ||
| Toshiba | 2939 | INT BLUE SCREEN | CHANGE TUNER | ||
| Toshiba | 2939 | FAINT BLUE SCREEN WITH NO MANUAL OR REMOTE FUNCTIONS | REPLACE ZP81 AND IC670 | ||
| Toshiba | 2812 | Servive Mode Access | press "F" and the av i/p key ( under the No 7) TOGETHER... then key 1 0 4 8 .. then "F" and green fastext key to move up the menu, "F" and Yellow to move down.. adjust with VOL up/down key |