Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
BEKO | 14.2 14.2 | No sound | Check and replace C178-4.7 nF | Mário Tavares | |
BEKO | 14.2 14.2 | Does not work by remote control | 3) R606-1 OHM T601-K2750 kontrol edin | Mário Tavares | |
BEKO | 14.2 14.2 | Picture is enlarging and then getting normal. Power supply voltages are normal. | Please check bad solder on pins of C519. | Mário Tavares | |
BEKO | 14.2 14.2 | Colours disappearing | Please change the C412 connected pin 62 and 63 of IC 101 ( IC TDA9563H/N1) from 56 pF to 39 pF and C413 from 33 pF to 39. Note : If the colours are still not correct, please insert 47 pF on pos. C412 and 22 pF on pos. C413. | Mário Tavares | |
BEKO | 14.2 14.2 | Audio problem | When the unit warms up the sound disappears first, then it stops reacting to the remote control or the frontpanel buttons. Picture can still be seen. Then you turn power off (mains button) and after you turn it back again, no sound, no reaction to remote AND THE PICTURE DISAPPEARS too. Check and replace C304 which is connected to pin 24 (Reset input) of IC301. | Mário Tavares | |
BEKO | 12.5 12.5 | Não funciona, Led não acende | R601-(4,7M) | ||
Beko | chassis 12.7 | falta de linearidade na parte superior da imagem | cond. smd C508 (15nF) estalado | ||
Beko | Chassis 16.1 | Tensão baixa na G2 | C712 2.2nf com fuga, este cond. mede bem mas em carga provoca o sintoma | ||
Beko | Chassis 16.1 | Linhas de retorno ao fim de estar ligado uns 20 minutos | R709 (220R) no circuito de apagamento alterada. Utilizar componente com maior dissipação | ||
BEKO | Chassi 12.7 | Fonte alim. nem sempre arranca | C610 10nF (SMD ) com ligeira fuga | ||
Beko | 12220T | Dead psu | C110 defective in psu 47uF, 25V - Resevoir cap for ic | ||
Beko | PT92 | E/W failure | Replace CD22 470nF and TV06 BD680 | ||
Beko | PT92 | High voltage for 5 secs. then goes into protection mode | Replace RV38 2R2 and DD07 BY228. Check CD22 470nF if o/c | ||
Beko | 30328T | White line down centre of screen top to bottom} | Replace C805 | ||
Beko | 12,8 | Red or Green or Blue screen | Check and replace on crt module : D702, D703, D704 all 1N4148 replace with type 1N4948T |