Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Aiwa | VXG142K | Dead with fast tripping aft power cut | C513/C538 1m 160v in psu hi esr | ||
Aiwa | VXG142K | Dead with st/by led lit - accepts a tape but no functs | ICP506 1A CP on tv pcb o/c | ||
Aiwa | VXG142K | Dead - no stby | R516 270k, IC501 TDA4605-3, Q500 2SK2397 | ||
Aiwa | VXG142K | Dead - no st/by | R516 270K, IC501 TDA4605-3, Q500 2SK2397-01MR | ||
Aiwa | VXG142 | No raster - OSD OK | Q1029 near tuner | ||
Aiwa | VXD2120K | Pin code resetting when lost | unplug set for 1 hour plus. reduce volume to minimum. simultaneuously press Volume down on unit and "7" to reset pin code and customer ID | ||
Aiwa | VXD1420 | Pin code removal | Enter wrong no 3 x, then press Vol- on set & "7" on R/C for 5 secs when "protected" appears | ||
Aiwa | VX9142K | Dead | R516 270k in psu o/c | ||
Aiwa | VTV CTV/VCR | Dead | R 519 100k STARTUP CIRCUIT. HT SUPPLY ( 103v ) VIA THIS CIRCUIT. SIMILAR TO ORION VTV. | ||
Aiwa | TVSE211 | No vid/raster with sound - no/poor OSD | IC303 (OSD Sw) pt no Aiwa87A21167010 | ||
Aiwa | TVC211 | St/by only | Replace EEPROM & R617 - the cause - which goes hi res | ||
Aiwa | SE211K | St/by only | R617 high (replace with 390K 1/4W) - located behind LOPTX.This causes the micro-controller to shut the set down and store this condition in the EEPROM. | ||
Aiwa | CXZR800K | At sw on relay clicks "DEMO" displayed then dead - keeps repeating | Check 2 x 2SK2723 FETs on sound o/p heatsink | ||
Aiwa | C202KER | Field collapse | Fusible link 1500 marked as jumper lead from loptx to reg via D6813 | ||
AIWA | AR295D | Linhas de retorno embaixo, variando de intensidade. | Capacitor C302 e resistor R307. |