Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81388
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDM8U | PART NUMBER FOR FP-10 FLEX CONNECTOR | S/M does not show P/N. Please inform. -HQ COMMENTS: P/N is A-7070-149-A. | ||
| Sony | RS20 | MISSING P/N - FLYWHEEL | Missing part number on Page 28 Ref #300. -HQ COMMENTS: Part number is A-3109-016-A. The reference number shouldbe #380. We will issue a service bulletin. | ||
| Sony | KV1515 | TUNER FAILURE FROM STATIC | Two units with complaint of tuner failure with static dis-charge to front controls. -HQ COMMENTS: Please try the solution outlined in S/B 200R especiallyaffixing copper tape to the control panel assembly. This grounded tapewill act as a collector of st | ||
| Sony | SLHF400 | FU-38 CIRCUIT BOARD PART NUMBER SUPPLEMENT 1 | P/N A-6717-395-B in Supp #1 subs to A-6717-395-A which is theFU-38 board for the SL-HF600. The SL-HF600 has some additional partsmounted on it and one interconnecting wire that should connect to CN305on the TM-82 circuit board, but will not because of t | ||
| Sony | KV1882AEB | NO VIDEO | The unit had no video. Sound worked fine. We found theproblem to be caused by D393 going leaky. This was preventing sufficientbias on Pin 18 of IC301. | ||
| Sony | CCDV8 | NO CAMERA VIDEO | No video in camera mode. One pulse missing from IC707. | ||
| Sony | CCDV8AFU | HORIZONTAL JITTER DURING PLAYBACK WITH VTR POWER ON | Unit would shutdown in REC mode when cam power was on, and inREC or PB mode when VTR + cam power was on. With only VTR power on, play-back picture had horizontal jitter. | ||
| Sony | CDXR7 | SLED INTERMITTENTLY WILL NOT MOVE | Intermittently the sled would not move from its innermostposition. When in the failed state the outputs Q509-511 would get verywarm. | ||
| Sony | KX2501A | NO START UP, REPLACED T653 | Set would not start up. B + 320V, and 160V present on GAboard. Troubleshooting showed only a negative going pulse to the base ofQ652. Also there was no pulse on the base of Q651. Located defectiveT653. | ||
| Sony | CDP302 | PART NUMBER INCORRECT IN S/M | Part number listed in service manual on page 58 item 79 is4-308-840-00. This is the incorrect part number. | ||
| Sony | SLHF900 | EATS TAPE | Very intermittently coming out of Beta-scan, reel motor slow,but not capstan. Results are tape damage since TU reel cannot wind itfast enough. -HQ COMMENTS: Problems of this nature are difficult to find. As wediscussed, if you send the unit to us we w | ||
| Sony | CCDV8AFU | NO CAMERA VIDEO | On CX23047B one pulse was missing. I think this is part ofmaster osc. giving color prob. | ||
| Sony | SL2500 | PART NUMBER FOR TABLE ASSY (CAP ONLY) | No part number for table assy - cap only - Ref #705 (cap forT-reel table). -HQ COMMENTS: This part is not available, nor is the reel table. | ||
| Sony | BMC550 | MISSING PART AND PART NUMBER | Need P/N for four screws that fit into Ref #374 on page 109.These screws are not shown in the pictorial. -HQ COMMENTS: The part number for the screws is 7-685-862-09. Forscrews BVTT 2.6 x 6. | ||
| Sony | XR740 | WRONG LABELLING OF HEAD PC BOARD SWITCHES | On page 41 of S/M for XR-740, 747R, 780 and 787R, thehead PC board switches are labelled incorrectly. Your recent S/B #62 hasthem labelled incorrectly. The parts listing on page 41 also has themincorrectly. S701 is on page 41 of the manuals, but you h |