Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CFSW501 | BATTERY LEAKING SHORTLY AFTER INSTALLATION | Battery is leaking, getting hot and going dead caused by theDC cut-off switch in the AC power plug. This causes DC from the powersupply to go into the batteries. | ||
Sony | VCL0752B | PART NUMBER FOR FRONT AND BACK LENS COVER | Need part numbers for lens covers (front and back). -HQ COMMENTS: Part numbers are as follows: Front = 2-395-025-01Please order from KCP. Back = 2-395-026-01 | ||
Sony | D55 | UNIT DEAD | After the unit was checked, found were IC503 was burned andDC to DC converter was bad. Unit was repaired. After 30 to 45 minutes itstopped playing. I found the same problem as before with IC503 burned andbad DC to DC converter. | ||
Sony | CCDV4 | GREEN PICTURE | After using the unit on R/P for 30 minutes, picture turnsgreen intermittently on IC-651 DC-DC converter. Pin 9 should have 7.7Vfound only 4.5V. | ||
Sony | CCDV5 | PART NUMBERS | On page 191 of the service manual item 18 and 2 are reversed.If you order X-3712-170-1, you get X-3712-046-1 part. The CCD-V9 manualshows them correctly. | ||
Sony | XR787R | TAPE DECK SWITCHED DIRECTIONS BEFORE TAPE END | Will not play 120 min. cassette to end of tape. Single lengthplay ok. 120 min. cassettes auto reverse within 1/4 of end. Found IC701clk. freq. (pin 2) to be 10.451 kHz. | ||
Sony | SPP110 | ICS ARE HARD TO REMOVE | The IC components are glued down with a red type epoxy. Wecannot remove them easily, if at all, in order to service unit. | ||
Sony | CFSW301 | BATTERY LEAKING SHORTLY AFTER INSTALLATION | Battery is leaking, getting hot and going dead caused by theDC cut-off switch in the AC power plug. This causes DC from the powersupply to go into the batteries. | ||
Sony | CDXA20 | WILL NOT START | Will not start. Spindle motor will not turn. Spacer thatholds motor shaft becomes dislodged from board. | ||
Sony | WMF8 | MOTOR PART NUMBER CHANGE | Part number 8-835-133-01 is a motor with a control board.This part number now subs to 1-541-414-11 which comes with no controlboard. | ||
Sony | CCDV8AFU | NO CONTROL PANEL PART NUMBER FOR COMPLETE ASSEMBLY | Reference number 105 does not include buttons - need completeassembly. -HQ COMMENTS: Please order X-368-677-21 for the complete assembly. Aservice bulletin will be issued shortly. | ||
Sony | HVM302 | IC3 ON DF BOARD IS 24 PIN, NOT 28 PIN | HVM-302 service manual shows IC3 with 24 pins, but unit hasIC3 with 28 pins. | ||
Sony | CCDV9 | INTERMITENT NO EJECT/LOOSE CONNECTION CN001 ON FP57 BOARD | Intermittent no eject. DEW indication appears on EVF (alsoapplies to S/N 210099). | ||
Sony | CDP255 | HOW TO POWER | Sears called to inquire how to test unit without main unit.As more of these systems are sold, I feel we should make a suggestion foran AC power supply to test these units individually. Also we must placevoltages required on schematic. -HQ COMMENTS: I a | ||
Sony | XM120 | SCREW GROUND | Protects after short warm-up (45 to 60 seconds). IC501 tripsRY501 when its pin 5 rises to -1.6V. |