Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDFX511 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the mode select switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
Sony | CCDFX510 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the Mode Select Switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
Sony | CCDFX411 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the mode select switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
Sony | CCDFX410 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the Mode Select Switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
Sony | CCDFX310 | PART NUMBER FOR MODE SELECT SWITCH | What is the part number for the Mode Select Switch? -HQ COMMENTS: Part number is 1-572-986-11. | ||
Sony | GEN-HFP | TIPS ON REMOVING 94 PIN FLAT PACK IC'S OR LARGER | Removing 94 pin flat pack ICs or larger. Example: IC-701TADM1000ES do not have the right Hozan tip to fit. | ||
Sony | TADM1000ES | NO SIRCS OUTPUT ON VIDEO ONE - IC701 (P/N 8-759-152-23) | No SIRCS output to video one or video two but other SIRCSoutputs are fine. | ||
Sony | KV32XBR35 | PIP PICTURE IS BREAKING UP, REPLACED P-1 BOARD. | Picture in picture would break up vertically. | ||
Sony | KPR41EXR95 | CENTER SPEAKER CONNECTIONS, SEE TV SERVICE BULLETIN 149 | Customer had professional installation of unit but could notget center channel to function. Found terminal connections on UT boardto be strangely configured. | ||
Sony | EVA50 | INTERMITTENTLY EATS TAPE | Contacts in connector not making contacct. | ||
Sony | EVC40 | INTERMITTENTLY EATS TAPE | Spring contacts in connector were not contacting. | ||
Sony | CCDTR101 | IMAGE STABILIZER INOPERATIVE | Found flex unsoldered at W-101. | ||
Sony | SPPA60 | NO BATTERY BACK-UP | Unit has no battery back-up. Power LED always flashes. Foundtwo different problems, Ref. No. 25 and/or Ref. Nos. 18/19 are missing onseveral units. Also, found that Ref. No. 19 is bent on several units,making bad contact to main board. Also applies t | ||
Sony | ITA205 | NO ANSWER MACHINE FUNCTION | Unit was unable to do any answer machine function (FF, REW,PLAY, OGM). Checked VCC and RESET. Both were correct. Checked forcrystal (X-601) at pin 24 and pin 25 of IC-602 and found no frequency.Found X-601 open. | ||
Sony | SPPA20 | NO POWER HANDSET | X-502 was oscillating at the right frequency but theamplitude of the signal was insufficient to operate the micro. Thedefective crystal amplitude was down 50 percent. |