Dicas Reparação
Modelo - Chassis
Pesquisa:
Resultados 83890
Resultados 83890
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | ICFC11W | L8 DISCONNECTED | No buzzer alarm. | ||
| Sony | CF520 | R401 OPENS | R401 opens and the motor will not run. | ||
| Sony | TCM121 | BELT JUMPS OFF MOTOR | Belt jumps off motor pulley due to lubricant getting on belt. | ||
| Sony | TAE5450 | TRANSFORMER RADIATING 60HZ | Hum in both channels. Volume control had very little effecton control of hum. If volume control turned up, tone controls wouldeffect hum. | ||
| Sony | STRV2 | BLOWN TRANSISTORS | Several units came in with blown power fuses. | ||
| Sony | ICF7750W | TIMER DOES NOT FUNCTION | Timer will not cut off after activating. | ||
| Philips | 14PV162 | Calling installation menu | The installation menu is activated by the following procedure: - switch on the set by means of the stop key. - Press simutaneously the cursor left and the cursor right key on the remote control. | ||
| Philips | 14PT156B | No pic (field collapse) - sound ok | R3449 4R7 feed res to FOP chip o/c - no other fault detected | ||
| Philips | 14HT3303 | Service code of the FM-Radio tuner. | In the partslist of the Radio-SP/LS-Vbatt panel of the Chassis Manual L9H.2E, the service code of the FM-Radio tuner item 1901 was not indicated. The service code is 9352 632 70112 | ||
| Philips | 14CN3001/05 | Int low contrast | Check preset res (chan scan) isn't shorting to crt aquadag | ||
| Philips | 14CN2201 | Dead - correct 100v HT on dummy load | Scan coils - had arced across rubber wedge | ||
| Philips | 12TVCR240/05 | St/by only - no line drive | UG06B clamp diode leaky | ||
| Philips | 12B312/15S | Dead. | Drys on sub PCB & BU type regulator. | ||
| Philips | 10CX1120/05R | power supply working but no line drive. | changed the following T539 / T534 / R537 / R502. LOPT faulty | ||
| Philips | 10CX1120/05 | Raster - distorted & no frame sync. | SKE bridge recy. |