Dicas Reparação








Pesquisa:

Resultados 83903

Dicas de reparação para:
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV2647RTUNING DRIFT, RESOLDER R053 Upon changing channels a good video will come on for a momentbut will drift off to barely viewable negative picture.
SonyKV2647RNO CONTROL OF BRIGHTNESS, BROKEN FOIL ON CRT BOARD No control of brightness. Picture would start at normallevel and slowly get dimmer with retrace lines, then flash to normalpicture level again. No G2 voltage on Pin 12 of CRT board.
SonyKV2647RPICTURE DISTORTION, REPLACE C549, C550 AND C554 Slight PIE CRUSTING and marginal horizontal sync.
SonyKV2645RNO REMOTE OPERATION, REPAIRED CRACK ON N BOARD Unable to control operation with remote. Found hairlinebreak on N board.
SonyKV2643RUNDER SCANNED PICTURE, R533 VALUE CHANGED, REPLACED Picture under scanned horizontally and vertically. Foundresistor R533 changed value, should read 1.2 ohms, read 14 ohms.
SonyKV2602VERTICAL FOLDOVER, REPLACED IC502 Vertical foldover at bottom. All voltages around IC501 andIC502 checked good except Pin 5 of IC502 which was very low, waveformswere distorted.
SonyKV2145RNO VIDEO/SOUND, REPLACED PRESCALER No video - no sound.
SonyKV2145RDARK PICTURE, REPLACED BRT CONTROL Unit loses brightness (goes black) intermittently. VoltageOK, TP49 goes low whenever problem occurred. Found brightness controlshorting to its case.
SonyKV1946RDEAD, FBT Flyback arc over.
SonyKV1946RSOUND NOISE, REPLACE T206 This unit had a background hiss in the sound. AdjustingT206 did no good. Found T206 had the incorrect transformer installed.P/N 1-403-360-13 was marked on the outside.
SonyKV1913SHUT DOWN At turn on, set would shut down after a few minutes to a fewhours.
SonyKV1913NO SOUND Sound goes on and off, cooling C226 would confirm problem.
SonyKV1746RSHUT DOWN, INSTALLED C547 AS PER T/N This unit would intermittently go into HV shutdown.
SonyKV2644RINCORRECT TUNING, REPLACED IC2002 Set would stay in address position A at all times. I foundwhen I turned channel set switch on and programmed set, it would work OK.But if I shut the set off, and turned it back on again, it would come onin position A and could not be addressed again.
SonyKV2643RNO OPERATION, REPLACED C539, C805 AND R812 Set inoperative. Found R812 open and C805 leaky. Replacedthem and picture displayed vertical bar (approx. 5 inches) on left side,R812 was running warm. Found C539 open.




Verifique se o esquema está disponível na área de downloads