Dicas Reparação







Pesquisa:

Resultados 82459

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyTAF5ADEFECTIVE D363 Unit came into FSC with burned R360 and leaky Q352. Staticcheck of other components showed no gross shorts or opens.
SonyTAF3ATRANSISTORS SHORTING TO HEAT SINK After the output transistors have been replaced, and unit hasplayed, the outputs will go out again.
SonyTA4650DC BALANCE DC balance on the speaker outputs is determined by matchingof Q302 and Q303.
SonyTA2650REPLACEMENT TRANSISTORS ARE IMPROVED Customer complained of noise with volume control at midposition, standard input levels.
SonyTA2650SWITCH OUT OF PROPER LOCATION No audio output on any function - function switch (S1) wafers180 degrees out.
SonySTRV55LEAD DRESSING NEEDED Whining noise from processor with no FM signal and muting off.
SonySTRV55WIRE NUMBERS ARE REVERSED Incorrect wire number. Numbers #1 and #3 reversed.
SonySTRV35DEFECTIVE OUTPUTS The NPN output transistor opened on one channel of each ofthese receivers. No other problems found.
SonySTRV2P/N FOR GLASS Cases of concealed damage to front glass on these models havebeen reported. Present solution is to replace entire front panel assemblybut it is costly. -HQ COMMENTS: A similar situation developed on the STR-4800SD, -5800SD,-6800SD models 3 years ago.
SonySTR7065PROTECTION TRANSISTORS REVERSED Burned main amplifier board was replaced (X-482-232-50).Amplifier clipped at 1 watt out.
SonySTR212DEFECTIVE IC20, 301, Q301, 302 No AM or FM - IC201 voltages incorrect, Q301 collector read 11volts. Replacement of individual IC, would knock the other chip out.
SonySTC7000ADJUSTMENT NEEDED The maximum deflection on tuner input meter did not correspondto center channel on tuning meter. Adjustment of FM discriminator and FMIF was unsuccessful.
SonySQA2030DEFECTIVE Q701 Noise in back channel outputs. -HQ COMMENTS: Replaced regulator transistor Q701, 2SC1124.
SonyPSX70WEAK MOTOR Tone arm would not complete return and play cycle wouldstop widway most times.
SonyPSX40DEFECTIVE MGH Turntable speed erratic. Maximum output from MGH was 15-20MVp-p. Even slight readjustment of the head caused it to scrape theplatter.



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads