| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sanyo | 25DN1 | St/by only - light goes out when brought out of st/by | R620/621 120k 2w in psu - beware of mains smoother being charged! | ||
| Sanyo | 25BN2 | Int sw off | Dry joint coll Q611 in psu | ||
| Sanyo | 21MT2 EC5A21 | Int dead | R481 dry joint | ||
| Sanyo | 21MT2 | Starts up then shuts down quickly | R495 180k | ||
| Sanyo | 21MT1 EC3-A21 | Poor, flickering pic | Low RGB o/p IC101 TDA8361 IF/Dec/TB chip pins 18 -20; chip faulty | ||
| Sanyo | 21MT1 | Dead | Replace R321 (120K) Primary Side of PSU O/C | ||
| Sanyo | 12T234 | Small picture. | |||
| Sanyo | 6144 | POOR VIS - LOOKS LIKE CRT FAULTY | A602 THICK FILM UNIT | ||
| Sanyo | 2180 | WONT GO COMPLETLY INTO SBY. LOW SUPPLY TO PIN 1 OP | CHECK R572 470ohm | ||
| Sanyo | 2148 | STEPPING UP CHANNELS | D24 5V1 ZENER | ||
| Sanyo | 2145 | INT SHUT DOWN | 100mfd CAPS 5v - 12v LINES | ||
| Sanyo | 2144 | NO TUNING WHEN COLD | C398 100mfd 5v LINE | ||
| SANYO | CTP-3791P | Não liga | R620-120K R621-120K | ||
| SANYO | CTP2796 | Brilho cintilando, cor no máximo sem ajuste. | Resistor R213 (5K6). | ||
| SANYO | CTP3720 | Sem brilho, com cor. | Resistor R435 aberto de 33k. |