| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Jvc | C14E1EK | Dead, in standby, HT present at relay RLX401, no 12 volts at C419 | R425 5.6ohm o/c, ZD402 12 volt zener s/c and C426 2200uF, 25volt faulty | ||
| Jvc | C14E1EK | Tuning drift,worse at high channel no's | Dry joints inside tuner unit, connections between edge of pcb and lugs | ||
| JVC | C14E1EK Onwa | Set comes on to standby - relay clicks. | R323 ( 6k8 5watt ) fusible resistor o/c ( maybe Int ) between p42 of IC301 & HT rail. | ||
| JVC | C14E1EK Onwa | No go | R323 ( 6k8 5watt ) fusible resistor o/c between p42 of IC301 & HT rail. | ||
| JVC | C14E1EK Onwa | Int snowy pic at sw on with no OSD or R/C functs | OK once TMS73C47 micro reset (s/c pin 32 to chassis briefly). Caused by crack in print at front edge of pcb on track to pin 2 micro - hard to see due to covered in black ink | ||
| JVC | C14E1EK Onwa | Dead - no st/by | Q902 2SB774 base emitter s.c. (used BC558). | ||
| JVC | C14E1EK Onwa | Dead - HT high | C909/911 47µ cured HT problem but still dead; No supply pin 42 AN5601K dec/tb chip IC301. R323 6k8 5w fusible o/c | ||
| JVC | C14E1EK Onwa | Dead | After replacement of usual caps the mains smoother C907 4700pF 500v in psu pri was found to be leaky | ||
| JVC | C14E1EK -Onwa | St/by only - can be int | lop stage 12v low at 11.5v - R434 0R68 hi res at 1R2 | ||
| JVC | C14E1EK | Tuning drift | C116 sm cap - also check other sm electrolytics whilst tuner out | ||
| JVC | C14E1EK | Stuck in StBy , relay clicks but no go . Or very rarely comes on and then goes to StBy after 3-4 mins . | R323 6K8 5w fusible OC. | ||
| JVC | C14E1EK | St/by only | C406 220µ 25v | ||
| JVC | C14E1EK | No Txt | SAA5243P/E on Txt pcb faulty | ||
| JVC | C14E1EK | Line Tearing | C632 | ||
| JVC | C14E1EK | Int destruction of fop chip (IC401 LA7830) | Replace VR901 (2K) +B preset. |