Dicas Reparação







Pesquisa: KV1922

Resultados 11

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV1922TUNING DRIFTS Tuning drifts. No problem if substitute VC supplied from10VZ source.
SonyKV1922CRESCENT MOON EFFECT When set was first turned on, you have a full picture. Witha crescent effect on the left side of the picture, it was about 12 incheshigh. After approx. 1 min., this dark area would fade and then thepicture went into a christmas tree effect with about 4
SonyKV1922INTERMITTENT PINCUSHION Intermittent pincushion, changes every half an hour.
SonyKV1922NO AUDIO NOR VIDEO Set has no audio nor video.
SonyKV1922NO RASTER At full voltage, output (horiz) transistor would get hot andthen short. Found the horiz. drive (Q507) signal was distorted. Tracedproblem to C526 (leaky) causing bias to change on drive transistor.
SonyKV1922PICTURE DISTORTION Set had pincushion problem. Traced problem to Q514. Signalat collector was distorted.
SonyKV1922NO COLOR No color, found no 3.58MHz output at CX172. Traced problemto capacitor C330 (leaky, reading 300 ohms).
SonyKV1922PICTURE DISTORTION (PIN) Severe pincushioning and poor width. Q513 pin amp shorted andC810, IC546 to be dried up. After replacing these parts the pin and sizewere substantially improved. However during the first 5 minutes of opera-tion the left and right sides were pulled in
SonyKV1922JAIL BARS ON LEFT SIDE Jail bars on left side. Servicer had replaced flyback andyoke - no help.
SonyKV1922PICTURE NOISE Three inches wide bar at right side of screen top of bottomonly on HBO cable channel and only at customer's home only on thisparticular unit, other units tried and work fine. Servicer blamingcable co. Found 150pF capacitor between Q512 collector and gr
SonyKV1922NO LOW VHF No low band VHF-UHF OK. VHF high OK. No negative 6 volts atVHF HI terminal of tuner apply external -6 volts could tune in low band.Q102 VHF HI drive had no negative voltage at base troubleshooting found-12V rectifier being loaded.



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads