Dicas Reparação
Modelo - Chassis TX3
Pesquisa: TX3 Enviar Dica Resolvida
Resultados 32
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| PANASONIC | TX32DK1F EURO4 | Liga e desliga de seguida.Fica em SB | Q857 com fuga | Substituir | aseletronica |
| Panasonic | TX33AK10 EURO 5 | Procedure to reset eeprom | Press volume minus - on the set while also pressing the remote controls status button this button has a + sign by it and is located above the red text button, this should now have initiated the reset routine and displayed data should be seen | ||
| Panasonic | TX32PF10 EURO 4 | Over a short period of time the convergence of the picture gets steadily worse. Eventually it is so bad that even the teletext shows double or triple images when they are made up of a combination of colours. Pure colours: Red, Green or Blue are OK. | The Tube must be replaced. Apparantly this is a known problem to Panasonic, especially on 32" tubes. It has been known to happen both in and out of warranty. So far Panasonic when contacted have also paid for repairs when out of warranty 2 years old | ||
| Panasonic | TX33AK10 EURO 5 | Strange picture / bleary / movement blurr etc etc | This problem was caused by eeprom corruption, once the eeprom was reset the fault was cured note that after a reset reinstallation i.e. tuning will be required | ||
| Philips | 14TX3504 TX3 | Frame collapse. | R423 ( 33k ) o/c. | ||
| Panasonic | TX37A2 | LOW BRIGHTNESS + GETTING LOWER | Q355 ON TUBE BASE | ||
| Panasonic | TX33A1G | No sound/vis - raster present | Dry joints on IC3505/2401 3 leg regs on H board near front of pcb,which is the plugged in pcb on the far l.h. side. | ||
| Panasonic | TX32PL | Convergence errors | CRT faulty | ||
| Panasonic | TX32PK1W/S | Dead with 3.15A fuse o/c | Official mod to uprate fuse to 5A | ||
| Panasonic | TX32PF10 Euro 5 | Sound disappeared then also pic aft sw off | All volts rails ok -Replace faulty EAROM (IC1102) (X24C0503TA) | ||
| Panasonic | TX32DK2 Euro 4 | Int reverts to st/by | D868 & D875 U/S Part N/os IN4150T77 & BZX79A75A26A | ||
| Panasonic | EURO5 TX36PF10 | will not tune in any stations after auto-tune | replace IC1101 SDA5450C481 on E board | ||
| Panasonic | Euro 7 TX32PG30 | St/by only | Reset line volts going into U1 pcb stuck halfway - being loaded by faulty sm filter LC1118 in reset line | ||
| Panasonic | Euro 5L TX36PF10 | Tries to start up but shuts down into standby within seconds of pressing the power switch. | Replace the 2SC2925STA line driver transistor (Q502) which had an open circuit b-e junction and also replace the X24C0501UA EAROM chip (IC1102) which had become corrupted. | ||
| Panasonic | Euro 5 TX33PF10 | Sound but no pic | Perform 'self check' by pressing "-/V" button on set & "status" button on handset together. To exit switch off with power button |